Gunsmithing Remington 700 XMark Pro trigger sear spring

[oldfatguy]

Went thru the search a couple of times as well as looking at Brownell's but so far haven't turned up a source for the missing sear spring.

The little devil jumped out of place and to God knows where in the gray carpeted room as I was trying to put the trigger back in the action after a bedding job.

I would be very grateful if someone could tell me where to order a replacement or two.

Thanks,
OFG

 

[Scott E White]

Re: Remington 700 XMark Pro trigger sear spring

Brownell's will only sell you trigger/sear parts if your FFL is on file.
Midway, although a bit more, will sell to just about anyone who knows what parts to ask for.
http://www.gunpartscorp.com/catalog/Products.aspx?catid=11939
Numerich/Gun Parts not only has most of the parts in stock (at usually higher cost), but they offer schematic drawings, so you can see what piece is actually needed.
http://www.gunpartscorp.com/catalog/Products.aspx?catid=11939

 

[oldfatguy]

Re: Remington 700 XMark Pro trigger sear spring

Thanks for the info. It is exactly what I needed, ordered two springs this AM.

Again, thanks,

OFG

 

[Hateca]

Re: Remington 700 XMark Pro trigger sear spring

Or you could have just ask around to see if someone had a few just sitting around since that trigger gets swapped out a lot.

 

[BobC]

Re: Remington 700 XMark Pro trigger sear spring

I have a X-Mark Pro that I removed from my rifle. PM your adress and I'll send it to you. Good for parts only.

 

[coldboremiracle]

Re: Remington 700 XMark Pro trigger sear spring

+2, I have two of them that are broke just like Bob's, good for parts.

 

[Scott E White]

Re: Remington 700 XMark Pro trigger sear spring

Guess you boys ought to lighten-up your trigger-pull weights a bit. Or, practice taking off the safties before shooting!

 

[coldboremiracle]

Re: Remington 700 XMark Pro trigger sear spring

hahahahaha

 

[deadeye]

Re: Remington 700 XMark Pro trigger sear spring

I know this is an old post but does anyone have a sear spring for the X-Mark? Or an X-mark trigger for parts that has the sear spring?

Please PM if you have one.

Thanks!