Suppressors Rusty Nuts Design TBAC compatible brake

[Jackomason]

Has anyone had a chance to try one of these?

Muzzle Brake - Single Chamber Suppressor Mount (Thunder Beast Compatib

These are raw, heated treated brakes! Our single chamber muzzle brakes are precision machined out of 17-4 stainless steel. Weight approximately 2.3oz 1.5" Long 5/8 - 24 has .30 caliber bore 1/2 - 28 has .223 caliber bore .950 - 24 external threads with 20 degree taper - compatible with TBAC "CB...

rustynutsdesigns.com

At $75 it's hard to over look. It's obviously not a TBAC product but I ordered one and plan to proceed with caution.

Very curious how well it matches the factory TBAC CB. I'll put it on my Valk and update once I shoot it some. I figure that's a safe place to start.

This might be a completely poor driven purchase but it could be worth it, right?

 

[Ledzep]

Once upon a time I machined a single square port into the end of my 1.25" straight contour barrel, and matched the 20 degree taper and (I can't remember diameter) x 20 tpi threads of the TBAC brake. Effectively making the above brake integral to my barrel, but with a little bit larger port... Anyway, the end result offered noticeably less recoil reduction than the TBAC brake, but worked fine suppressed. I'd imagine you'll notice similar results.