This is my first trip to the Form1 SBR rodeo...
I have a couple of Noveske Gen2 stripped lowers. I need to get them engraved and ready for the Form1 process.
I'm trying to read ATF Form 5300.4 (pg #92) and it looks like I need the caliber or gage on the receiver in addition to my trust name and city/state.
From the factory, Noveske isn't putting the caliber or gage on the receivers.
Is this an extra piece I need to have engraved when I goto my engraving shop ?
If I need them to add that as part of the engraving, what should I have my engraving guys put on there ?
This is ultimately going to be a 223 (556 chambering). Should I put 556 on it to avoid confusion down the road ? I'm probably OCD'ing out on this too much but I could see my barrel being stamped 5.56 Nato and the receiver and Form1 say 223 and getting screwed somehow.
Thanks for any help.
I have a couple of Noveske Gen2 stripped lowers. I need to get them engraved and ready for the Form1 process.
I'm trying to read ATF Form 5300.4 (pg #92) and it looks like I need the caliber or gage on the receiver in addition to my trust name and city/state.
From the factory, Noveske isn't putting the caliber or gage on the receivers.
Is this an extra piece I need to have engraved when I goto my engraving shop ?
If I need them to add that as part of the engraving, what should I have my engraving guys put on there ?
This is ultimately going to be a 223 (556 chambering). Should I put 556 on it to avoid confusion down the road ? I'm probably OCD'ing out on this too much but I could see my barrel being stamped 5.56 Nato and the receiver and Form1 say 223 and getting screwed somehow.
Thanks for any help.