Preparing to ship a Jet 13x40, should I remove it from the base? The pallet I made is 3' wide, far wider than the lathe itself. Was just thinking I would make it very clear on the crate that it is top heavy and which end is the heavy end. It only has to go about 500 miles. I was also going to build a brace that would be attached to the spindle that would prevent rocking forward and back.
I think when you buy a new lathe like this it comes with the bed just bolted to the pallet, but Im not sure if that is just for cost reasons, and it has to travel 6000 miles.
I think when you buy a new lathe like this it comes with the bed just bolted to the pallet, but Im not sure if that is just for cost reasons, and it has to travel 6000 miles.