Does anyone know the reason behind TBAC choosing to place the taper behind the threads? I know this Mount is rock solid repeatable, not knocking it. Just seems like if the taper were in front, no carbon build up would make it to the threads.
Suppressors Tbac taper mount question
- Thread starter NorthWesterner
- Start date
The shoulder seals up so it’s pretty moot. The geometry on smaller diameter cans works better this way.
Which shoulder do you mean? I know the taper seals. Like I say, no knocking it. I run tbac exclusively. My engineer brain was just curious.
Misspoke, sorry. The threads don’t really get so bad because there isn’t gas flow back in that direction
Makes sense. I haven’t had my cans long enough to have any opinion. I care most about repeatability and your mount does that extremely well. I trust you guys know what your doing. Just always wondered about this. Thanks for chiming in.
