Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Ohh!I did ask her , she said you were awkward strange bitter little man, probably abused by women at some point , bad dancer and a worse tipper and poor table manners .
And even with her busy schedule you made a lasting although poor impression
They are very spicyI think badlands is loading a mag length 80 grain cartridge using the nas3 casings. It is supposed to be pretty spicey
no one is going to arrest Gates. the solution to him and his ilk is extra legal. never happen. Stalin and Mao never got punished. they had total societal control. Gates has enough control,deep state and NWO players, to stay free to continue his mass murder projects.
Thank you for the advice, I do already have the cam indexing block picture and have been using it awhile now.Yes. In general you can prep on one tool head, then dump them into a bulk cleaning operation, followed by loading on the next toolhead.
Just some suggestions.
Consider an adjustable index/depth-stop to allow primer depth control. Sometimes variations in brass will cause seating depth issues but with an adjustable stop you have options.
View attachment 8686481
Consider that the Dillon trimmer is a straight flat cut. It will leave the mouth of the case sharp on the ID.
In some instances, that sharp edge will cause issues with bullet seating when it scrapes and cuts the bullets.
You can either try to deal with an inside chamfer, or you can run a flare. The flare only needs to allow the bullet to sit and enter without scrape marks and will be gone when you taper crimp or full crimp.
Lee makes a universal flare die kit. Many of us that run bulk ammo use it to flare and avoid needing to manually deal with the chamfer. It is inexpensive and works well. Good Luck.
View attachment 8686479
Damn, you went thru all that stupid-speak in 5 minutes? I've wasted at least 10 now.....This has been 5 minutes in my life that I will never get back and I have only myself to blame.
Yep.Much past 10x most would say it’s a little too thick
I'm not the smartest Marine in the crayon box but even I know that refusing a gift from the leaders of such countries is an absolute insult to the person offering the gift.
Even a stupid E-4 knows that there would be massive problems arrising from such a stupid move, it's that simple.
President Trump is an honorable leader that was gifted an airplane to use because Boeing isn't capable of producing a new Air Force One in a decent timeframe.
I wonder why our last president wasn't given the same airplane.