Hi all
Anyone using the Autotrickler V4 with N565, looking who's got good speed/accuracy, and what settings they using.
G
Anyone using the Autotrickler V4 with N565, looking who's got good speed/accuracy, and what settings they using.
G
Two questions.The secret to the v4 is tilt. When you run the calibration cycle on the v4 the small tube flow rate should be around .2. The instruction manual says a min of .15 but I have found it runs better closer to or just over .2. If you are not at .2 then add tilt until you do. The other adjustments are easy after that. I have the shim kit and use the #3 shim with N565 and average about 10 seconds a throw.
Can you point me to these shims? I just got my atv4 and use n565 and I made my own shim from cards but figured I seen labeled shims would be awesome switching powder. I did just lower the legs on scale and had it running great but then I figured if I switch powder be easier to make shims. I'm roughly at .21 and get throws in 15 sec rangeThe secret to the v4 is tilt. When you run the calibration cycle on the v4 the small tube flow rate should be around .2. The instruction manual says a min of .15 but I have found it runs better closer to or just over .2. If you are not at .2 then add tilt until you do. The other adjustments are easy after that. I have the shim kit and use the #3 shim with N565 and average about 10 seconds a throw.
I appreciate it I found it. The search wasn't working for me because I used shims not spacer. Are you still using #3 for n565?Reloading Equipment - Autotrickler v4 spacer mod
Hi everyone, my 10 year old son got a 3d printer recently and we have been busy learning how to make cool stuff. He has an entrepreneurial spirit and wants to offer up some of the designs we came up with. My son is printing, and shipping. All of the money goes to him, I am simply the middle man...www.snipershide.com
Search function works
No, #2 with a little lean on the feet - move bubble level towards top a little. Best advice is to play with it. Run the calibration until you get small tube to .2 - .22 and then adjust settings. Don't be afraid to tinker with settings. Everything I run in mine can do 10 second throws or faster.I appreciate it I found it. The search wasn't working for me because I used shims not spacer. Are you still using #3 for n565?
Awesome I appreciate the info!! Best I've done so far on 86 grains is 13 seconds most 15 seconds. So excited for spacers. I'm still learning all the settingsNo, #2 with a little lean on the feet - move bubble level towards top a little. Best advice is to play with it. Run the calibration until you get small tube to .2 - .22 and then adjust settings. Don't be afraid to tinker with settings. Everything I run in mine can do 10 second throws or faster.