I was loading up some load development rounds and ran into an issue with fed 205mar primers.
Up to 15% to 25% are getting destroyed while trying to get them to go in.
I ran this brass through a dillon 1050 to swage it.
When my dillon 550 would not seat the primer I bought a "swage it" for the 550 since I do not have the 1050 anymore.
Even using a rcbs hand tool they are often hard to seat.
Here is the kicker..... rem 7.5 primers seated pretty as you please????
Are fed205mar known to be slightly bigger?
I would highly prefer the 205mar work as I have many more of them than the rem7.5
What say you?
Up to 15% to 25% are getting destroyed while trying to get them to go in.
I ran this brass through a dillon 1050 to swage it.
When my dillon 550 would not seat the primer I bought a "swage it" for the 550 since I do not have the 1050 anymore.
Even using a rcbs hand tool they are often hard to seat.
Here is the kicker..... rem 7.5 primers seated pretty as you please????
Are fed205mar known to be slightly bigger?
I would highly prefer the 205mar work as I have many more of them than the rem7.5
What say you?
Last edited: