• Winner! Quick Shot Challenge: Caption This Sniper Fail Meme

    View thread

McMillan Z10 contour choice

Eric32

USAF
Full Member
Minuteman
Supporter
  • Aug 14, 2011
    1,888
    695
    Tennessee
    I just traded for a McMillan Z10 I like the stock alot. But I have no clue what barrel contours would balance out the rifle for barricades.

    Here are the build specs
    R700 223
    TT primary
    I have a SDN6 can that has been converted to a Q mounting system
    Undecided on scope as of yet

    Or is there some modeling program that based on stock and suppressor and scope generates a solution for contour and barrel length choice.
     
    I would like to balance it without the ckyepod attached since that's how I run barricade stages.

    I am also taking your switch barrel advice and copying your barrel setup on my MPA. Using a tenacity and prefit barrels with wrench flats on the ends.

    But the Z10 I won't be switching anything up and it will be my rifle that I lend out to friends that wanna shoot.
     
    Yea the z10 has a full arca rail.

    I think a 24inch m24/40 might be the way to go.

    You notice any sustained fire accuracy issues with the palma contours. I am talking the 12 rds rapid strings.
     
    I've got my RimX with 20" MTU in a Z10 right now. It sits a little rear heavy until I add my ckye pod, then it balances very well off barricades (not that it terrible without). When I put my 26" M24 308 BA in the Z10 with a can (OSS, which is heavy), its a bit too front heavy for my liking, especially with a bipod.
    IMO the 24" M24 will be offer good balance, especially with a can on the end.