Recent content by 390fe
-
3
Member Link Up Iowa shooters check in
The High Lakes range north of Afton has had additional dirt berms added to the rifle range. There are berms every 100 yards out to 600 yard, and there is also a 500 meter berm, and a berm at 770 yards. Range fees are still the same at $5 daily use fee or $45 for a yearly membership. 2216 130th...- 390fe
- Post #135
- Forum: The Bear Pit
-
3
Newbie
Welcome from southwest Iowa! There is a ton of information available on the site!- 390fe
- Post #3
- Forum: New Member Introduction
-
3
Great time to develop the skill set of precision shooting
Welcome to the Hide!- 390fe
- Post #3
- Forum: New Member Introduction
-
3
FNG from PNW
Welcome from Iowa! Hope you enjoy yourself at the Hide!- 390fe
- Post #3
- Forum: New Member Introduction
-
3
New Guy... Hello from MD!
Welcome to the group! Honestly, I learned to reload from a reloading manual many years ago, along with a bit of mentoring. With a good manual and the multitudes of reloading videos available on youtube, you should be well on your way in no time. The forums on this site also contain lot of good...- 390fe
- Post #7
- Forum: New Member Introduction
-
3
Milsurp Collector Going to try a modern gun
Welcome to the group! You can purchase your way into full membership status rather than making 101 posts. The shortcut to being able to use the classifieds can be found here; https://www.snipershide.com/shooting/account/upgrades/- 390fe
- Post #2
- Forum: New Member Introduction
-
3
New Member Looking for help on an estate sale
Welcome to the Hide!- 390fe
- Post #4
- Forum: New Member Introduction
-
3
Savage 10 Predator Hunter 260 Remington Loads
Do you know the twist rate on your barrel? Here is a post that may have some load data for you to try; https://www.snipershide.com/shooting/threads/260-remington.6252739/- 390fe
- Post #2
- Forum: Reloading Depot
-
3
New from Louisiana - BTR
First, let me say Thanks for your service to our nation, I appreciate it greatly! Welcome to the Hide! I have owned a Burris scope recently, and it did everything I wanted it to do. You will get better answers to your optics questions here...- 390fe
- Post #2
- Forum: New Member Introduction
-
3
Hello From N Nevada
Welcome to the Hide! Hope you find a better atmosphere here.- 390fe
- Post #2
- Forum: New Member Introduction
-
3
Tikka T3x CTR SS 20" 6.5CM - Stock Base Issues?
Good morning and Welcome to the Hide! Post your question to the Gunsmithing forum and you will receive better advice than what I can offer. I usually don't hear too many complaints about Tikka's quality. Here's a link to the Gunsmithing forum...- 390fe
- Post #2
- Forum: New Member Introduction
-
3
Question around Ejector Marks/Heavy Bolt Lift
2,698 fps from a 20 inch barrel is pretty hot in my opinion. The fact that FGMM and Prime eject properly without either sticky bolt lift or ejector marks - and have lower velocities would suggest that there is nothing wrong with your chamber or barrel.- 390fe
- Post #9
- Forum: Reloading Depot
-
3
Salt bath annealing
Unfortunately, that is a natural charecteristic of salt.- 390fe
- Post #2
- Forum: Reloading Depot
