Recent content by Dag34

should have grabbed the TBAC cert......damn it

6x47 had been pretty easy for me. My last 4 barrels have all liked the same load and shoot sub half moa and single digit SDs. Just run 6.5x47 through your die and you are good to go. My 26 inch barrels are running around 3050 with 105s and everyone has given me 2000 trouble free rounds. In...

Double check the magneto speed and put some new batteries in it too. Good luck, I hate chasing stuff like this.

Sheldon N- Gamechanger here also. I prefer the full size waxed canvas version. me too

McMillan A10 might be a good solution

My load for a 260 along with 3 of my buddies Been running 140s in my 6.5x47 140 eldm in the factory loaded 6.5 creedmoor

Anyone been using the Atlas for scanning? I clip my q14 to my helmet, works well.

It will be tricky to build the replacement door, in order to remove the hinge the housing has to be opened up.....bye bye warranty.

awesome, glad to be wrong

Just a cool rifle from 1984

I don't believe the N Vision has on board recording. From my understanding it is very similar to the Trijicons but has different glass, different housing and different buttonology.

I had that model when I first started off and when compared to 2 different magneto speeds all devices were +/- 5fps.....totally usable.

If I understand your point correctly you are complaining some one did not install the turret at the mechanical center...aka if it has 40 moa of total travel it should have 20 moa in each direction? LOL slip the turret and go shoot.....I'm out

Slip the turret to read 0......then forget about which direction has 4 moa extra travel. The set screw you can see when the turret is removed is probably for the "click" engagement when rotating. Just call NightForce, they are extremely helpful.

when I lived in an apartment I kept my handguns in a small safe stashed behind the HVAC air handler. Had a shotgun (870) with me and kept that leaned against the wall behind some clothes.