Recent content by fmjfirearms

I see a lot of references to holding edge of plate when shooting steels. I get that if the plates are close in there's no need to dial in windage just allow for the wind. But you guys seem to do it at longer ranges, past 600? In the UK a lot of guys dial for wind and aim centre plate and adjust...

Nobody, has that combination and can check for me? I thought there were loads of members using both? Cheers Mark

If anybody has a Sig 2400 BDX LRF & Garmin 701, could they confirm something for me please. I have them both, when I am in ABU mode on the Sig and ping a distance I get the drops in the LRF and in the App on my phone. If I am in ABE mode and connected to the Garmin 701 I get the range and drops...

It does, but try getting them! They are not available here in the UK, are they in the US? Interestingly I tried a AICS mag in my AXMC Long action and it fed 6.5 CM perfectly.

MCHOG Rear 0.613" Front 0.589"

deersniper, I paid less than £100 pounds UK here. I broke 2 lots of Butler Creek style at £20.00 each, gave up and spent the wife's money on something to last.

Gentlemen I would like to thank everybody for their help. Got a new magazine today, works perfect. Also using the dimensions of the new one and a lip tool I made up, I have the old one working perfect as well. Result! Thanks again members of SH the best forum going! Cheers from across the pond Mark

deersniper, It's called a Sniper Hider made here in the UK. It is a protector for the scope, it screws on to the scope and opens by turning the knobs. You can have it open in stages to stop glare. I have a optical clear filter inside it to protect the front scope lens as I shoot comps in a giant...

Hi AXMC Yes its velcroed. With my arm length it was slow to retrieve rounds when mounted on the forend. I had to break cheek weld, where it is now its easy to reach the rounds. The quiver is rock solid, i used the stiff 50mm plastic velcro.

I have a new AI AXMC long action. I cannot get 6.5 rounds to feed out of the .308 mags. They just slam into the barrel face. I know some guys have got them to feed, any tips or ideas. Cheers Mark

Hi Guys I will be competing again this year in the Czech Republic Snipers Cup. The last 3 years and this year is at the same range...a giant soft sand pit. Every year shooters suffer from their bipods sinking in the soft sand after repeated shots. I have tried a rubber mat, then carpet stuck to...

My V3 is also very tight, I might just take off a few thou on the sides.

Hi Can somebody tell me what CLR stands for? It's like everyone should know? We don't have it in the UK. Unless it's under a different brand name?

What's everybody's thoughts on vibrating cases to settle powder so you don't compress loads? I have been doing it for about 10-15 seconds on a vibrating mat so I don't hear that crunching sounds when seating a bullet.

Hi As far as I know, but stand to be corrected a 701 does does use DA. It uses the presure reading at your location and temp with your loaded profile and location for results?