• The Shot You’ll Never Forget Giveaway - Enter To Win A Barrel From Rifle Barrel Blanks!

    Tell us about the best or most memorable shot you’ve ever taken. Contest ends June 13th and remember: subscribe for a better chance of winning!

    Join contest Subscribe

Recent content by glockaholic

  1. glockaholic

    Ohhhh Fuddddge!!

    I didn't read the rules.
  2. glockaholic

    SOLD: Giraud Case Annealer

    Very sorry but it sold on another site.
  3. glockaholic

    SOLD: Giraud Case Annealer

    I'm selling my Giraud Case Annealer. $375 + actual shipping and insurance. https://www.giraudtool.com/giraud-cartridge-case-annealer.html subject to prior sale.
  4. glockaholic

    Analyze these targets with me

    I've heard that you either should be into the lands or out, not close. A piece of paper is .003 and being 1 or 2 thou off on individual cartridges will have more influence when close to lands. So either .010 in or .010 out is more consistent. Your gun seems to like .020 out so go with that. Less...
  5. glockaholic

    Rifle Scopes Scopes Slipping

    I carefully line the rings with electrical tape. It keeps marks off the tube and offers some grip between the surfaces. Also I use a sharp pencil to mark the scope location.
  6. glockaholic

    8 inch or 8.5 inch 5.56 barrel

    8 inch or 8.5 inch 5.56 barrel Most suppressor are not to be used with less than 10.3" due to increase muzzlel pressure. On some it will void the warranty.
  7. glockaholic

    Rifle Scopes Mid Range Tactical $1500 and under, HELP ME

    $900 Bushnell 3.5-21 FFP Bushnell Elite Tactical 3.5-21x50 TRMR2 Scope ET35215T On Sale
  8. glockaholic

    Night Vision PVS14 camera adaptation

    nicely done. I like your setup.
  9. glockaholic

    Sidearms & Scatterguns convert glock 23 to 9mm ?

    I told LW that the logo sucks. They should delete it and just put LW. Like my kids, they don't listen. On your crappy barrel, create a small radius at the top of the feed ramp (top of the water fall). I use a dremmel with a fine sanding cylinder. Follow the sanding with polishing. Polish the...
  10. glockaholic

    Sidearms & Scatterguns convert glock 23 to 9mm ?

    The ejector on the 40 is straight and on the 9, it's bent in a little. Easy to swap. .... Memory not as good, I maybe backwards on the 2.
  11. glockaholic

    Sidearms & Scatterguns convert glock 23 to 9mm ?

    Mms
  12. glockaholic

    RO Bushnell Brawl, Thank You Sponsors

    The Bushnell Brawl was my first PRS Match and was very fun and educational. I didn't know what to except and was impressed by so many folks offering help and advise. Jacob, Premo, Shawn, Wade, Matt, George and many others took time to offer coaching and answer my endless questions. Also thanks...
  13. glockaholic

    Which 6mm?

    I use a 6SLR and it works hard for me. At 3100fps it's only 6.7 mil vertical at 1000 and still supersonic at 1500 yds. This is with 105 hybrid bullets which use a 1:8 twist. If use use a 7.7 twist then you can use the heavier 115 DTAC bullets. I don't think they will fit in a regular magazine...
  14. glockaholic

    JP not timing correctly

    I can't tell for sure but you could try a trick I used once. Take the crush washer (or a spare) and sand the narrow end of the washer. If you sand too much or screw it up then you're only out $2. I put a sheet of 320 grit on the table saw and rub the washer back and forth. Test again. Finish...
  15. glockaholic

    GA Precision Current Lead Times 9/18/14 update

    Couldn't any state request the information from the ATF?
See more
Top Bottom
Back
Home
Forums
Merch
Alerts