Recent content by honeybadger65

Innnn

The picture sucks but thats all I have. There is for sure a gap between the rings, and it is noticable, just not in the picture. I just want to find out if its normal to have a difference or not.

I'm not sure if there is the same gap on the opposite side. Are the ring tops not interchangeable? There is a goooood chance I mixed them up if they are not interchangeable. My problem is that the game is not the same on each ring. One ring has a much smaller gap than the other. Should the...

Hello all, This was my first time installing a scope/base/rings and had a questions on what is/isnt normal. I have a Rem 700 w/Seekins base, low rings, and a Bushnell LRHS. The base did not need bedding. When I put the scope on the rings (without the scope ring tops) the scope fits pretty...

How do you think the balance would be on a 20 incher in that same contour?

What do you think about a 20" Sendero with one of the EH stocks? Specifically, a MCS-T?

Wonderful. Your 100% correct and that is exactly what I am experiencing. Bolt "pull" is the same between the two. Bolt "lift" is harder after pulling the trigger. Thanks for your help, just wanted to make sure that was normal.

Two triggers? The issue I am having is with one trigger after I fire. Some people have said that what I am experiencing is that I am cocking the trigger and this requires additional force. The main question I have is as follows: After you pull the trigger and before you pull the trigger, if...

Hello all, I recently installed a Timney 510 in my Remington 700. When the trigger has not been pulled, the bolt is very easy to pull and is smoothe. However, after I pull the trigger the bolt gets a little tougher to pull back. Its not extremely hard to pull or anything, just a little...

Thanks for this Ryan!

I ordered a MCS-T w/mini chassis from Manners Stocks (GREAT customer services by the way) for my stock Rem 700 AAC-SD. Do you guys think its necessary to send my barreled action in to Manners to get fitted or are the stocks w/the mini chassis truly bolt and go? Thanks, -HB65

Any idea if this scope would work with a Seekins base and Seekins low rings? Sendero contour. Thanks :cool::cool::cool::cool:

Hello, I currently store my 16 inch AR15 in a soft case which fits perfectly inside of a pelican case (with desiccant of course). This setup works really well for long term storage as I do not have to worry about moisture from the foam. I want to have a similar setup for my 20 Inch AAC-SD...

If the magazine system on the Tikka is adequate I dont think I would need the mini chasis, would I?

I'm looking for a .308 rifle that I can use for long range shooting and some hunting. The rifle will be run suppressed. Weight is a concern but so is cost. The way I see it I can get a Remington 700 AAC-SD and put a Manners MCS-T with a mini chasis. I recently started looking at the Tikka T3...