Recent content by Hummer

They were sold complete at first by that big outfit that buys up end stocks of guns. Seems they were out of Texas????? At any rate I have a buddy in Atlanta that got the whole rifle and when those were gone they sold barreled actions and finally sold only actions when is when I found out about...

I have a FN Police action (Mod 70 Win incognito)that has the FN made removable mag lower metal and 10 shot mag (308 win). I understand these were originally issued with Hogue stocks? Anybody got a line on a stock for a FN Police Sniper rifle? Thanks

Re: Stainless Steel Media Testimonials I loaded up on Ivory several years ago when it was much less cost wise at Wally World. I have like 25 bottles laid in. I got a gallon of Dawn at Sams for like 8.00???? and it works as well. Main thing to add is Lemishine.

Re: Stainless Steel Media Testimonials Congratulations Terry, I think this is a all time record for the Hide??????

Re: Stainless Steel Media Testimonials .062 media I believe would stick like glue in flash holes or large rifle cases and they are about .060" range. Can't say about .500 long.

Re: Stainless Steel Media Testimonials Too much Lemishine will turn cases copper colored. Been there, done that. A 9MM case is all you need for Lemishine or a 40S&W case full. I use 1/2 ounce of Ivory. Dawn will work but they are a little darker for me. I have 30o bottles of Ivory laid in.

Re: Stainless Steel Media Testimonials just make sure not to get that magnet near your computer! ! !! !

Re: Stainless Steel Media Testimonials I guess I am just lazy. I size my cases like I am going to load them (neck or FL) and leave the lube on and let the Ivory and Lemishine do their thing. I figure if it removes the carbon the other stuff removed is just a freeby plus and saves an extra...

Re: Stainless Steel Media Testimonials Unfortunately if clean brass is exposed to the air it is going to tarnish depending on local conditions. The soaking in Lemishine apparently leaves a protective coating for lack of a better term on it. Putting them in freezer bags may well keep the...

Re: Does barrel wear effect ES/SD? Did you record each shot in string? When I do long runs I shoot 10 and tally and continue on for another ten and at times you can detect rounds going faster as barrel heats/fouls.

Re: using a chamber stub? just wondering, does the stub have throat in it? When I make them I used the same reamer and I run it in to about 1/8" below the shoulder. I trim back the front end till it has just a thin shoulder where the front of the chamber stops and none of the lead. You can...

Re: Have you ever blown the base clean off? Dr. Phil, good info on the ruptured shell extractor. Did not know Midway had them. cstmwrks: yep a guy has to have good measuring tools to know where he is. I try not to throw away any brass as sometimes it comes in handy for different projects...

Re: Have you ever blown the base clean off? Former navel person is right on the mark and with a few good measuring tools and die selection it will never happen to you again. Here's how: First off get a good micrometer and good calipers. Measurement on cases is made in several places. First...

Re: Stainless Steel Media Testimonials That rinse is different from what I saw at Wally World so will have to get some of that I reckon.

Re: ruptured primers Javy, Is your striker nose perfectly hemispherical and having no sharp edges or tool marks? So you have small holes. Assuming there is no deformation of the striker nose I have to concur that you may have a lot of thin cups which happens to all manufacturers sooner or...