Recent content by Shooter71

1 shirt in a medium. 😬

When you’re done collecting data and testing theories and calculating stuff.... put some loaded ammo in the lathe and run some more tests and calculations, and report back. You might be surprised to find we’re shoving some pretty crooked stuff into relatively less crooked holes.

Damping, not “dampening”. 😁

One of them is the bottom of the ejector spring.

I know, wasn’t directed at you, just for clarity.

My point is they’re freakishly consistent, even compared to custom actions.

Correct. Measured actions, not chambered barrel spec.

Actual headspace measurements from recent Tikkas, only stopped because I didn’t want to get another binder out.

Excellent barrels!

Agree completely. Trigger alignment is probably not related to the barrel alignment at all, but is related to bedding which is the first place I’d look for both issues.

It’s pretty easy to roll an action a degree or three during bedding and have the trigger off center.

Alignment down the channel also depends on the method used for dialing the barrel. If they dialed at two points at the chamber end only, and didn’t index on the vertical plane can show up, if the barrel has a little English in it. I’d ask the shop to remove the bedding and see how it sits in the...

Cool idea! Any limits on bags, support etc? What kind of format are you thinking? Maybe see how it evolves after a few shoots?

Did you mean .002”, instead of .020”? Might’ve been a typo. .002” would be appropriate, .020” would definitely lead to case stretching and separations. You probably know, but for anyone that might be reading, head separations can be pretty dangerous and potentially hurt you and the rifle. If...

Your headspace is likely long, which isn’t a big deal if you’re setting your fl sizing die properly. If you don’t know exactly how much back you’re setting your shoulder, for that chamber, you need to.