Recent content by -Time-

My universal strategy for working up a load is lightly crimping a bullet bullet in a fired case set long, carefully chamber and remove to measure the distance to lands. Then I load up a ladder test with the bullet either touching or with a little bit of jam. Pick the accuracy node and velocity...

Is anyone running these at sub and super velocities? How finicky are they, and how efficient are they? I’m debating hard about going this direction for a 300blk imitation with better supersonic capabilities, hopefully 155’s closer to the 2500fps range.

Give CSTactcal a ring. Highly recommend the TT and it’s where I’ve bought all of my high dollar optics from since that TT.

I have an ultimatum deadline in a KRG whiskey 3 that also runs both perfectly. I had to trim the mag catch for action fit, but AICS and AW mags both feed flawlessly, no matter what kind of pressure or where I put on the mags. The deadline is AW cut with an over insertion stop. As far as I could...

If it’s purely a hunting rifle you’d be fine sticking to 300wsm or wm, I’d personally pick wsm of the two for that. I have a 300wm thats primarily a long range target rifle, that occasionally sees some deer hunting. I handload 225gr ELDs for it, and when it comes time to rebarrel I’m going...

I inquired about getting a custom barrel done about 2 or 3 weeks ago and heard back in a day or two. Maybe the spam filter caught your email? I know my gmail puts the weirdest stuff in there.

The bcg/upper touches the gas tube already, I don’t think there’s any noticeable impact on accuracy. The little anti-rotation piece is clearanced to not really impart any force on the gas tube anyways. Really all of the anti rotation is done with the clamps at the bottom. I’ve beaten the ar10...

Nothing wrong with your parts list. V7 is good stuff, and I’ve been known to splurge on some unnecessarily expensive parts because I can. I have a preference toward the LaRue MBT triggers, replaced my geisseles with them. (and they’re a steal at $80). I also have nothing but great things to say...

Interesting. Hopefully we can get some data piled up to get drop in prefits made for deadlines at some point then. I can’t imagine ultimatum would hold tolerances that wouldn’t headspace from one action to another.

Gonna end up sending it to PVA I think, I was hoping to avoid having to ship the action but oh well. If you have the numbers and don’t mind PM’ing me what the measurements were for the low s/n action was it’d be much appreciated, I have sub s/n 230.

oh no

I had the manual open and I still missed it, I’m a dumbass. Thank you!

You’ve clearly misread what I’ve said. I’m asking for the specific standards you hold yourself too. You named time of flight, I assumed you had an actual number that you held yourself too, given that you keep mentioning math and specifics. I consider the sum of the factors that influence my...

Indeed it does. Nothing wrong with being inexperienced and reading on this site, there’s a wealth of knowledge passed around for those willing to listen. Bolty if you do find yourself tempted to post in a thread where you don’t have experience, it’s probably better to listen, or ask a question...

Anyone with a deadline gotten one done? Is there a tenon spec out there for drop ins? I’m looking to move to shouldered barrels with wrench flats so I don’t have to pull the rifle apart to swap barrels. Thanks!