Search results

Brownells still has CCI small pistol primers. Just ordered 2000. Thanks for the heads up, Bullet!

I may be late to the party, but it seems that there are no pistol braces on either Brownells or Midway. I haven't checked any other sites yet, but I was surprised to see them missing.

Does anyone know where Berger 140 Hybrids are in stock?

As the title says. Get them while they last.

Gasgun thanks for the info. I'm assuming if I am planning on running it unsuppressed I should step down the buffer weight.

Jigstick, you don't need to do that if you don't want to. What setup are you currently using the A5 for and what buffer weight?

Has anyone compared the VLTOR A5 system to a Geissele Super 42 system for a 10.3 in barrel and a standard gas block and bolt? If so what was your experience and what buffer weight did you use, H, H2, H3, etc. I am planning on use M193 but any input is great. Thank you for your feedback.

I have the sporter but wish I had spent the extra couple of bucks for the V3 because of after market accessories such as the Mpa spigot mount or a rail mount. Measurement wise the sporter has been great on both bolt guns and an AR.

What is the benefit to using the area 419 funnel kit over a basic plastic funnel?

Where have you been looking?

I'd rather not buy a new $100 trickler. I more wanted to know what insert that was to see if it would work in my current trickler.

What manual trickler and reducer are you using?

Yikes! That is not what I wanted to hear.

Does anyone know where I can find CCI 450's in-stock?

They have both 8lbs and 1 lbs. Go get some while they are still in stock!

Thanks for the input everyone!

Is there any problems going back and forth with coated bullets and plated bullets?

What are your thoughts (pros/cons) on reloading and shooting polymer coated bullets in 9mm handguns (glock and cz)?

I am looking for a reamer that will allow me to use 178 eldm and 175 SMK close to the lands (20 thou) while being able to feed from a magazine max case length of 2.9 (2.875 to be safe). Through reading many forms I think I have decided on 0.090" freebore. Does this sound right? Also just for my...

I don't have a lathe so I'd have to do it with a hacksaw. Hopefully solvent and or torch does the trick.