Search results

I don't know if this really belongs in gunsmithing. I have a laminated wood stock that I have worked on so that it fits me. I'm considering cutting the top of the comb and setting it up so that I can adjust the comb for eye alignment to the scope. Now I'm using a ctg. sleeve with dense foam...

I want to make copper bullets open quicker. Would annealing the tip (only) back to the ogive of the bullet cause quicker upset? If I anneal the whole bullet it would cause barrel leading a lot quicker, wouldn't it? Thanks, scpaul, been gone a while due to health, hope that I'm back for a long...

I found a new pkg. of Otis Lifeliner that I forgot I had. Other than their (OTIS's) reviews, I can't find anything about it. Did anyone actually use it?? It's not shown on their website at this time. I have seen it on old posts(2008+-) run down,called snake oil, called BS, but nobody said they...

I'm building a wildcat on a Savage116FSS(stainless).I'm using a Boyd's laminated heavy varmint thumbhole stock w/a blind magazine.I want to bed the metal magazine & remove the metal mag.I believe that reforming the metal piece would cause problems because of the way it is attached to the assy.It...

what about a .270/.300 Win Mag? Would appreciate anyone's thoughts.

would I be Better off money,expense,and quality wise to send just the bbl. or the whole weapon. Note I would have to buy bbl nut wrench & go/no go gauges. The differances between the 2 seem mostly case length & neck diameter.suggestionson a smith and approx. cost each way. THANKS paul