I have a new custom 6mm dasher and i bought a set of Forster reloading dies for the rifle. My FL die is still a tad bit tight after Fl sizing the brass. the bolt closes but it seems a little stiff. I have herd folks talk about sending fired cases of to have a die made. Who would do this service for me, for the best cost?? Thanks Lee
Re: 6mm dasher die needed
I have heard of people taking a little off the bottom of the die or better yet the top of the shell holder to get the case further in the die.
I have heard of people taking a little off the bottom of the die or better yet the top of the shell holder to get the case further in the die.
Re: 6mm dasher die needed
C&H Tool >> Link to C&H Tool
They can take care of you for sure! I had two 308 FL dies that would not get a full length size on my case camming way over. Sent it back to the Mfg. and tell them you can't get a FL size. They should fix it no questions asked. IF not return it if you have the receipt or sell it on Ebay and buy one from C&H.
Terry
C&H Tool >> Link to C&H Tool
They can take care of you for sure! I had two 308 FL dies that would not get a full length size on my case camming way over. Sent it back to the Mfg. and tell them you can't get a FL size. They should fix it no questions asked. IF not return it if you have the receipt or sell it on Ebay and buy one from C&H.
Terry
Re: 6mm dasher die needed
My good friend suggested i take some off the shell holder, so i will try this first!! Thanks Lee
My good friend suggested i take some off the shell holder, so i will try this first!! Thanks Lee
