Gunsmithing CDI bm and older Savage 110--Update

[Texgal_338]

recently installed the CDI BM on my pre-accutrigger M110 Savage 300WM

here's where i had to mill the action




here's views of it inlet





here's a view of interior



feeds using a dummy on the workbench; waiting on a range day

Update
Took it to the range, worked great. No binding.

 

[JCH]

Re: CDI bm and older Savage 110

i wish my wife could do that.....

who am I kidding, I wish I could do that!

 

[rcnpthfndr]

Re: CDI bm and older Savage 110

TG338

whats the dimensions of those cuts? i have a couple 110 actions in the safe.

thanks

ETA: do you have Higher resolution pictures? if so could you email them to me? thanks again

 

[Texgal_338]

Re: CDI bm and older Savage 110

i just have a dial mic, not a digital; that said

cut the front pillar to .400" and the rear to .872"; didn't measure everything though.

had to trim the front screw to .745 and the rear to 1.555; this does NOT include the screw head

 

[rcnpthfndr]

Re: CDI bm and older Savage 110

thanks TG338 appreciate it

 

[cav has been]

Re: CDI bm and older Savage 110

Nice job TG! That CDI bm is first rate.

 

[SDWhirlwind]

Re: CDI bm and older Savage 110

I congratulate you TG on your job and commend you for your desire and determination to tackle projects like this!!!

With that said though, damn woman you sure know how to denut and drain the testosterone from all the 10 thumbed guys that frequent this forum

90+% of them don't have the determination nor courage to tackle jobs like this.lol

You're like me as far as learning, always figured if it didn't kill me and cost less than a couple hundred bucks I was willing to try it once for sure

 

[Texgal_338]

Re: CDI bm and older Savage 110

SD

this was a first for me; took 3 saturdays; learning experience

 

[762frmafr]

Re: CDI bm and older Savage 110

you should hire out your services...TOP NOTCH for sure..