Worked pretty good, I have had the ultrasonic for years, use it to clean internals on all the MG's, works like a champ.
Have been reloading .308 for a few years but don't clean that brass, neck size only.
Going to start reloading .45acp so thought I would give it a try, this brass is from MG shoots over the past few years and some was wet when put in buckets, so it's pretty dirty, gritty, tarnished, etc.
Deprimed all the brass and put 500 cases at a time in the Crest, came out clean for the most part, not as shiny as tumbling, but I was just worried about getting the grime off so I can process it, not worried about the shine at this point.
Before
The beast
3 Dirty on the left, 3 clean on the right
Have been reloading .308 for a few years but don't clean that brass, neck size only.
Going to start reloading .45acp so thought I would give it a try, this brass is from MG shoots over the past few years and some was wet when put in buckets, so it's pretty dirty, gritty, tarnished, etc.
Deprimed all the brass and put 500 cases at a time in the Crest, came out clean for the most part, not as shiny as tumbling, but I was just worried about getting the grime off so I can process it, not worried about the shine at this point.
Before
The beast
3 Dirty on the left, 3 clean on the right