Glock 48 MOS Iron Sights

Cold_Bore_88

Sergeant
Full Member
Minuteman
Jul 13, 2013
526
68
The Woodlands, TX
Gents,

I need a recommendation on iron sights for my Glock 48 MOS. I bought the MOS in case I ever decide to put a red dot on it. Unfortunately, this make finding tritium iron sights a little more complicated. I would like a 3 dot tritium sight set. It doesn’t have to cowitness. I would like to keep it as low as possible.

The only thing I can find is full cowitness 3 dot or single dot front.

Any advice?
 

Jigstick

“Women see that and they know”
Full Member
Minuteman
  • Jul 21, 2017
    1,892
    2,138
    Pittsburgh PA
    I’m kinda in the same boat. I put a Holosun on mine using the adapter plate. And my stock irons are juuuuuust a tad low to view through the window. I believe Truglo makes a set that raises them slightly. Something to consider depending on what optic you intend to run.
     
    • Like
    Reactions: Cold_Bore_88

    JimmyJr

    Makin Chips
    Full Member
    Minuteman
    Sep 20, 2021
    1,086
    851
    Idaho

    Cold_Bore_88

    Sergeant
    Full Member
    Minuteman
    Jul 13, 2013
    526
    68
    The Woodlands, TX
    One of these is probably the route I would go. Then if you get a red dot later just get a good one and forget about trying to cowitness.


    Thanks! Ended up ordering the ameriglo. Just a heads up, I tried the Trijicons first but they will not work with the MOS. They have over the back side too much.