Suppressors just discovered my AAC Titan QD is M18x1.5, need 5/8'sx24

[rockwind1]

man, after I forrest gumped my way thru removing this stuck QD adaptor for my 338 titan,, i discover it's a more unique thread than i had hoped(m18x1.5). should have looked at it more closely.

i can't seem to find any online,, where would be best place to find one?

i tried area 419 but they dont' even make an adaptor for their setup according to drop down choices.

 

[_Windrider_]

man, after forrest gumping my way thru removing this stuck QD adaptor for my 338 titan,, i discover it's a more unique thread than i had hoped. should have looked at it more closely.

i can't seem to find any online,, where would be best place to find one?

i tried area 419 but they dont' even make an adaptor for their setup according to drop down choices.

Call 419. I bet they have a solution. The drop downs don’t show every combo just the more common ones.

 

[rockwind1]

i sent them an email already

 

[_Windrider_]

i sent them an email already

User @flyer1a is area419 also. They always answer when I call. Good peeps.

 

[Old Man with Gun]

Suppressor Thread Adapters

Our adapters are manufactured from 300 series stainless and are black oxide coated. We use stainless since suppressors produce a good bit of moisture and corrosion. Our adapters are guaranteed to …

trosusa.com

This guy does custom, but might also consider threading barrel to common size.

 

[fast freddy]

Ecco machine can change the mounting setup to use more common mounting solutions, or have a thread adapter made

 

[flyer1a]

Have ECCO convert that thing to an Omega rear cap, and the world will be your oyster.

 

[rockwind1]

Have ECCO convert that thing to an Omega rear cap, and the world will be your oyster.

i sent you a message, can you explain that further?

 

[Waorani]

https://eccomachine.net/

 

[wwl]

Thread Adapter M18x1.5 RH to 5/8x24

Thread Adapter M18x1.5 RH to 5/8x24

www.silencercentral.com

 

[rockwind1]

Thread Adapter M18x1.5 RH to 5/8x24

Thread Adapter M18x1.5 RH to 5/8x24

www.silencercentral.com

i really appreciate that, but believe it or not, i need the opposite one. i need an adaptor that has female 5/8x24 for end of barrel and then has male m18x1.5 male sticking out because my current only qd has female m18x1.5 threads, so was just going to keep using the same qd if i can get an thread adaptor.