Ok so I just got my new stock and put my action into it and dry fired once and now everytime I cycle the bolt the firing pin is dropping. Not with any force at all. It's just going in one slow fluid motion with the bolt. So I took my action out and now it is STILL doing it and will not let me turn it on safety
!!!!please help!!!!! Trigger problems
- Thread starter 308sniper147
- Start date
You may have got some loose material from the stock in the trigger. I cant imagine it would go from functioning 100% to not working based off of adjustment.
Well then, just take that POS off and put a decent trigger on that rifle, there, done.
Check to ensure that the trigger hole in the stock is not touching the trigger at all. I have heard of the stock keeping the trigger pulled so it did this.
Ryan
Ryan
Break down the bolt, clean the gunk out of the bolt body/firing pin. If that's not it check the trigger/sear alignment. Had the same thing happen on a customers 22-250, WD-40, gun gases create a nice goo. DO NOT USE WD-40 ON GUNS!!!
Similar threads
