Just the other day I took a rifle out of the safe to do a bedding job on it. When I removed the barreled action from the stock, I noticed shiny wear marks on the top of the bottom metal, then noticed the trigger pin was half-way out of the trigger housing. Looks as if it had been that way for some time. I pushed the pin back in and did the bedding job.
While I was waiting for the epoxy to set, I took the other two Savages out of the safe as they both have SSS triggers as well. Upon removing the actions from the stocks, I found that one of them had the trigger pin sticking half-way out of the housing.
That's two out of three. I pushed them back in and found it odd that I hadn't noticed before as the triggers functioned just fine. I'm not bitching as this was an easy fix, and I like the SSS triggers otherwise. Just wondering if any others who use the SSS "Competition" triggers have had a similar experience?
Good Shooting,
Jim
While I was waiting for the epoxy to set, I took the other two Savages out of the safe as they both have SSS triggers as well. Upon removing the actions from the stocks, I found that one of them had the trigger pin sticking half-way out of the housing.
That's two out of three. I pushed them back in and found it odd that I hadn't noticed before as the triggers functioned just fine. I'm not bitching as this was an easy fix, and I like the SSS triggers otherwise. Just wondering if any others who use the SSS "Competition" triggers have had a similar experience?
Good Shooting,
Jim