Suppressors Silencerco specwar762

[jb41291]

Anyone who has one, any problems with your specwar suppressor coming loose while shooting. Mine comes loose after about 10 rounds from the rifle. My lock ring stays in the locked position but notice the teeth have disengaged from the teeth on my asr brake. Pretty much opens my groups to over 1 inch at 100 yards when this happens. Anyway just wanted to see if any one had this same problem or any recommendations before i send it into silencerco for warranty work.

 

[LSUbeatUby40]

Anyone who has one, any problems with your specwar suppressor coming loose while shooting. Mine comes loose after about 10 rounds from the rifle. My lock ring stays in the locked position but notice the teeth have disengaged from the teeth on my asr brake. Pretty much opens my groups to over 1 inch at 100 yards when this happens. Anyway just wanted to see if any one had this same problem or any recommendations before i send it into silencerco for warranty work.

I just got mine and have about 50 rounds through it. I have not had those issues. Hopefully I don't either.

 

[charger23]

It sounds like the teeth aren’t engaging well to begin with. You can take something like a screwdriver and bend the triangular tooth section of the locking ring (open it more) to give it a more secure lockup once the locking ring is engaged and I bet you won’t see this happen again.

 

[charger23]

[No message]

 

[jb41291]

It sounds like the teeth aren’t engaging well to begin with. You can take something like a screwdriver and bend the triangular tooth section of the locking ring (open it more) to give it a more secure lockup once the locking ring is engaged and I bet you won’t see this happen again.

thank you, i have tried this before it worked for maybe 100 rounds then same problem started happening again.

 

[charger23]

If you’ve already done that I would contact silencerco and have them swap that ring. Perhaps a bad batch, incorrect tensile strength.

 

[Badfinger]

After you screw it on and lock the ring can you unscrew it?

Can you try it on a different asr?

 

[jb41291]

If you’ve already done that I would contact silencerco and have them swap that ring. Perhaps a bad batch, incorrect tensile strength.

will do. they have sent me 2 brakes to test out if it was worn down teeth on the brake. but like you said most likely the ring.