Re: X mark trigger adjustment???
+ 1 on the search
However, I will fast track you.
The picture shows the only screw that one has to adjust for the X-mark{at the tip of the pen}
Take a pick,razor blade or whatever and dig the glue out of the screw.
Give this screw a twist and a half out.
This should get to around 3lbs. if the trigger was factory set @ 5lbs.
I say only one and a half because frankly in my opinion if this trigger is set lower then eratic behavior begins.
After this leave the saftey off and cycle the bolt atleast dozens of times very roughly to see if the pin drops.
Slam the butt of the rifle on a hard surface also.
The next step is to put a few bucks in a jar every week for when this trigger needs to be replaced ,you will know when it happens.
If you are doing your dry fire exercises, like you should, it is a matter of time.
http://www.snipershide.com/forum/ubbthre...9003#Post999003