Filter

New Build #4 Ridgeline RD15 / Geissele 18" SPR Cut Rifled Barrel. (03JUN25) First Range Session up.

Okay Boys and Girls I took the new RD15 out for a quickie Range Session between Honey-Do tasks.

The barrel shoots exactly the same as my others Geissele Cut Barrels, very accurate. The Mirage today was just a FPITA!! But still turned in some solid groups.

The Geissele Barrel in the RD15 loves the same handloads as well. I didn't have any 24.3gr TAC, 77gr SMK
Handloads leftover but I did have 5rds of 23.8grs and it easily printed Sub Half MOA.

These are literally the first 20rds down the barrel.

I'll hit the range this week early in the morning and give it a solid break-in. I'm 110% confident if I shoot those four loads again with no mirage none will be over 1/2 MOA.


20250603_155831.jpg

Chinese state sponsored terrorism?

have been a long time. way past time to expel about 90% of all Chinese students and profs. and just because they are US citizens means dick. a lot of spies have gone that route and think they are safe.
Chinese are groomed from an early age to be what they are going to be. So yes, I am agreeing with you, while they may be sent to Harvard to be a doctor, they knew from age 5 they were being groomed to be a doctor and their allegiance is paid for by the CCP, with family as the unwilling ransom, just in case they go rogue in the good old USA.

6gt gap 10

I ordered a gap 10 in 6gt yesterday. This is my first large frame gasser and it will be for PRS stuff. I ordered the 20’ but thinking maybe I should go for the 22’ instead. It will be shot suppressed. Anyone else running a 6gt gasser? Opinions? Things to look out for? I may run factory hornady for break in but planning on 105 hybrids or even 109 handloads for the duration. I do hear that large frame ar’s can beat up brass, any way to avoid this? Thanks!!

In Honor Of Kill Dozer Day. This is The Way To Have A Second Type Of Event

Yet another example of local politics being infiltrated by people who got pushed down in the playground, didn’t get their way at your birthday party, and never got mommas tit out of their fucking mouths.
Local politics is where it’s at gang, if you want shit going your way get involved.

B14r hard closing ? Cock on close?

I have an older bergara and when you close the bolt slow you can watch the firing pin go down then back up a little as the bolt handle body / ramp sets the cocking piece on the sear ( there is clearance ) while the bolt lugs engage the lug recesses and pull it forward , it feels like it is partially cocking the firing pin to many people
I believe the timing is off
Yes it’s frustrating that bergara won’t sell parts or I would try messing with it more
  • Like
Reactions: PappyM3 and vaguru