Latest activity

Hot Threads

Latest activity

 Posts Forum list
 

Filter

Rifle Scopes Arken Zero Stop, set up for speed drop?

J
Bmghunter said:
YES you can adjust the zero stop to go below zero. I have done so myself. That inner ring with the ridge has some set screws using tiny Allen keys I believe. I had to buy special tiny Allen keys for that, forget if it’s metric or imperial. Anyways, loosen those set screws, put the cap back on but not tighten the screws and rotate the cap with the zero stop down to rotate the inner ring, stop when you rotated enough down for the stops you want.
Click to expand...
Micro key set - 0.9mm.jpg Thought I would resurrect this thread as I recently purchased the DNT 7-35. I also wanted a zero stop below "0" on my rimfire. The size of the small allen head screws is 0.9mm as seen in the set I purchased on Ebay. I unthreaded the small screws and before attempting to turn the ring with the machined portion, I marked the inner turret noting the postion of the machined potion relative to the turret. Unfortunately, the ring would not budge. It's almost like the ring is loctited in postion. Rather than use more force or an instrument of mechnical advanatge, I accepted the stop at 0.
Click to expand...

6ARC gas systems and A5 buffer systems and factory ammo...what's the baseline?

D
WeR0206 said:
Hmm…maybe bump down to A5H0? How spicy was the ammo you were shooting?
Click to expand...
factory 108 and 105. I don't reload

I might try an A5h0 eventually for grins; however, this is just fine for the time being getting use to this gun/cartridge.
I also don't have the utmost faith in short, stubby mags anyways compared to their standard capacity counterparts and sheer spring length/tension dynamics.

If it starts failing to lock back on a Duramag 20 or higher capacity Geissele, that's more of a concern.
Click to expand...
  • Like
Reactions: WeR0206

Is N150 a throat torcher??

Rob01
diggler1833 said:
Yep, .223 Wylde. I'm also using Starline brass.

Different barrels run different speeds.

*****

@Rob01 I think you were looking at the possibility of speed with the .223 Wylde and N150 a few months ago, weren't you? This may be the ticket, and I just have a slow barrel.
Click to expand...

I have good 223 Wylde loads but I think I was asking about the 6 ARC and N150.
Click to expand...
  • Like
Reactions: diggler1833
Load more
Top Bottom
Back
Home
Forums
Merch
Alerts