Latest activity

steve123 · Aug 16, 2025

Take airguns for example, you'll get the best of the shot if you use good form and follow through on the shot. Don't change your hold or anything else if possible and you'll be rewarded.

Semi's if shot the same way can shoot great. The fact is you need to finesse the shot because you can't get away with some things like you could with a heavy centerfire bolt gun.

lockedandloaded · Aug 16, 2025

A few select M24 systems to be auctioned off tomorrow 8/17/2025 by Rock Island Auctioneers at their Bedford, TX location. One is the incredible M24 Lease Contract rifle (1-of-16) with Remington archive documentation, originally purchased by an Illion, NY employee after being returned from the U.S. Army Fort Riley, Kansas. The other one is an early Remington Collectors Edition 25th Anniversary (1987-2012) version (1-of-less than 2000), with the scarce "G" prefix ser.# that pre-dates the later "RR" prefix recievers. Cant wait to see where the hammer drops

aprocast · Aug 16, 2025

I could see it on the hip of some bloke in Africa with a fancy double rifle a hundred years ago.
Edited to add those pukka old poms didn’t carry their own guns, that was the job of a blackboy, and the blackboys weren’t trusted with ammo.

sirhrmechanic · Aug 16, 2025

Photo taken on a SWAT deployment a couple of days ago. LE Marksman/Observer deployed on the callout. Neighborhood cat decides it's a good place to catch some sun.

Totally epic photo! Because Cats know who they are safe with. And who is a warm body as well.

Sirhr

lash · Aug 16, 2025

And you just know that she will go after the department for wrongful termination. She had already started building her case at the end of that recording.

steve123 · Aug 16, 2025

No it's not worth the hassle and I know this because;
I could roll WSSM brass on a flat surface and see the run out of the neck.
The primer pockets were all over the place in depth and in other aspects.
Flash holes were horrible as in not centered and there was a lot of brass burs punched into the inside of the case which I reamed off.
I benchrest prepped all of my 243WSSM brass including neck turning and after doing all that my groups shrunk by half.
That batch of WSSM brass was very inconsistent, so much so I threw 25% away, some before I did anything and some after I did everything to it.

Yeah it was a screamer but that's about it. Really only 1 moa if that but this was in a AR. I sold it shortly afterwards then got a 6mmART40 from whitely which was such a great cartridge using Lapua brass. This brass was the opposite in quality compared to WSSM and only down 200 fps or so. Plus it shot tight for an AR, even won a night match with it.

I'm kinda sticking with normal cartridges nowadays because of the pitfalls I ran into when going for extremes. Give me a 6mmBR for normal distances and a 6.5 Saum for longer and I'm good, those are my go-to's now.

lonegunman762x51 · Aug 16, 2025

Maser said:
Ah yes...The classic "you're too much of a coward to do the job yourself" argument. Gotta love the armchair commandos of the internet.

Spoken like a gutless armchair commando from the internet. Proves my point perfectly.

sirhrmechanic · Aug 16, 2025

Please take a moment to remember John Cruickshank the last remaining Victoria Cross recipient from WW2. He led a daring raid against a U-Boat and saved his crew in an incredible feat of bravery.

John Cruickshank - Wikipedia

en.wikipedia.org

It is not fair to say that 'they don't make them like this any more." Because there are his equals and betters who served in Korea, Vietnam, Somalia and both Iraq and Afghanistan.

But he is the last of a generation of warriors who saved the free world long before most of us were born. And deserves to be remembered by his fellow-warriors and their adjuncts.

RIP, sir. You saw and did things most of us can never imagine. And then went on to live a famiily life as a mild-mannered banker. Nothing could be a greater requiem for a real warrior.

Sirhr

Silvan · Aug 16, 2025

AXMC LE joined the “AI family”…

Mk32784 · Aug 16, 2025

Bump $900

lash · Aug 16, 2025

Here you go: M24 29” 6.5 7.5:1 in stock at Bugholes (Southern Precision):

Bartlein 6.5mm 7.5 twist SS M24 29''

www.bugholes.com

They’ve also got it in Heavy Varmint.

Snuby642 · Aug 16, 2025

Measured things to hell and back.
The seconds kinda suck. Lol

The Sierra 69g smk's are giving me problems getting an accurate measurement to the lands.
I have cleaned the chamber and still not consistent.

Is there something about the bullet shape to ogive that's giving me a problem?

I have not yet got a Sierra manuel, I'm told they offer a separate set of loads for ar's?

I have a custom seating plug on order. I think the bullets are bottoming out in the stem.

jmar · Aug 16, 2025

That doesn't seem too far off for a MK13 without optic and a stripped case. If it's still the same as a it was a few years ago they some hefty buyer fees so actual price after all fees and taxes are likely 10k+. Just googled it buyers premium is 18.5%.

steve123 · Aug 16, 2025

I've lost 2 decent knives so far and they were both Micro's. Each the same way meaning they jostled out of my pocket from the loose fit on my pockets.

I prefer magnacut steel fixed blade knives now though. This special steel has most of the qualities of SS and much that of high carbon steel so it's very hard and doesn't rust easily. The 62-63 ish HRC means it'll hold an edge a long time.

For more basic shapes Dawson knives have been unbeatable in best bang for the buck. These aren't mass produced cheap knives but more of a semi custom with a small shop fashion and flare. Each one comes with a sheath and a Ulticlip to attach so it carries well in a pocket and you won't loose it because the tensioned clip fits hard on the edge of the pocket or if you prefer on a belt using their standard belt hardware.

Here's mine so far but I plan on getting a few more at least.

Duc · Aug 16, 2025

That S&S is FANTASTIC!!

mtrmn · Aug 16, 2025

24.5 gr tac with 55gr fmj is definitely accurate in every ar15 I have tried it in. You have to understand you're dealing with bulk grade bullets, unsorted brass etc.

FLIGHT762 · Aug 16, 2025

Just measure you fired cases from each of you rifles (I would measure 5+cases or an average) and make notes for each rifle.

My first year production SR-25 fired cases measure 1.631"(tight chamber) and my 2013 era GAP 10 fired cases measure about 1.634". Your Rifles should be in about the same neighborhood. These measurements are calculated from the comparator number length and converted to the SAMMI minimum go gauge length.

Don't be surprised if you get some higher datum length numbers on a Rifle that could be over gassed. I have a buddy that has a Les Bayer AR-10 that shoves the fired cases shoulders forward to 1.640". There's no way I'd believe that Les Bayer cut that chamber that long. The cases were from Factory Federal GMM. He gives me the cases to reload.

M1-A's & M-14's are notorious for shoving case shoulders forward on extraction. On the two M1-A's I own, I turn the gas spindle off and fire 5 rounds without the gas and then measure those cases to get a more accurate fired datum length.

baker72 · Aug 16, 2025

Hunting

Maser · Aug 16, 2025

"Verbally resisting" while cuffed?

Maser · Aug 16, 2025

No need to play Taps over it. Appliances that age were meant to be maintained and repaired over the years. It's not like the cheap bullshit today that are all disposable.

jmrod0720 · Aug 16, 2025

Weibad Tater tot Heavy fill Non Skid $80 TYD

https://diprecision.com/tater-tot/?searchid=11930&search_query=tatertot

Crosstac BFB Front Shooting Bag (Big Front Bag) ultra light foam filled $35 TYD

BFB Front Shooting Bag (Big Front Bag)

Buy BFB Front Shooting Bag online with Crosstac. Check out our collection and pick the best BFB Front Shooting Bag from us at an affordable price. Shop today!

www.crosstac.com

Cole-tac Boss Bag $30 TYD

Boss Bag | Cole-TAC Outdoor Gear

Buy Boss Bag from Cole-TAC | One of the best ways to get a rock solid shooting platform | Boss Rifle Support Bag | Rifle Shooting Bag | Rifle Shooting Rest

www.cole-tac.com

oneshot86 · Aug 16, 2025

MWAlex2 said:
Login to view embedded media

That's awesome

Latest activity

Latest activity

Filter

Attachments

Attachments

Accessories Weibad Shooting Bag and more

Attachments