Hi guys,
Hope all of you are well. Looking to see what you guys have done to lower the pull weight of the stock 2 stage trigger that comes w the barret mrad smr. I have the 6.5 CM version and was tempted to buy the Barret 2 stage flat trigger from Barret but upon looking into it, the indicates the lowest recommended setting was 1.75 lbs. Timney offers a curved 2 stage trigger as low as 1.5 lbs. ideally I wanted to get something to the 1 lb to 1.25 lb. what options have you guys seen out there outside of these two?
A thought inhad was, instead of spending the 315-400$ on a new trigger I was thinking of replacing the set screw on the factory trigger with a shorter one that would allow me to keep it flush but shoot to lower the trigger past the 2.25 lb threshold the booklet indicated. Anyone tried this?
In either case I will call Barret about changing that set screw amd see what they tell me. Thanks in advance for the share of info.
Damian
Hope all of you are well. Looking to see what you guys have done to lower the pull weight of the stock 2 stage trigger that comes w the barret mrad smr. I have the 6.5 CM version and was tempted to buy the Barret 2 stage flat trigger from Barret but upon looking into it, the indicates the lowest recommended setting was 1.75 lbs. Timney offers a curved 2 stage trigger as low as 1.5 lbs. ideally I wanted to get something to the 1 lb to 1.25 lb. what options have you guys seen out there outside of these two?
A thought inhad was, instead of spending the 315-400$ on a new trigger I was thinking of replacing the set screw on the factory trigger with a shorter one that would allow me to keep it flush but shoot to lower the trigger past the 2.25 lb threshold the booklet indicated. Anyone tried this?
In either case I will call Barret about changing that set screw amd see what they tell me. Thanks in advance for the share of info.
Damian