Alpha. Definitely saw some pressure signs and lower velocity than expected. My AX gets ejector "shine" on pretty much all brass, including mild 6.5x47L Lapua brass, so I'm not concerned about that. I didn't get any swipes. But I did get cratering and primer flow at 34.5gr Varget and up. Primers weren't flattened though.
I shoot a 24" barrel so I expect about 50fps slower than everyone else. With the 110 A-Tips I was only at 2855fps at 34.1gr Varget, then started seeing pressure. 35.0gr at 2920fps was the high node, but the primers looked terrible and that was only at 35F outside.
My next step is to seat them further off the lands than the 0.010" I was doing, most guys are saying 0.030" for the A-Tips, possibly more. I'm at 150 rounds now so I think I can do a bit more refined load development. I don't expect the barrel to speed up much more but we'll see.
I ran my 6.5x47L w/140 Hybrids at 2700fps for the past 4 years, so I'm not a speed chaser. Low node all day. So if I can run the 110s at 2850fps with no pressure and in the middle of a fat node, I'll be good with that. I shoot 100% suppressed for matches so I'm willing to give up a little velocity for the shorter barrel length. The reason I'm willing to try the A-Tips is at 2850fps they shoot the same or inside of my 6.5x47L, with 30% less recoil. And it shoots about the same as a Dasher w/105s at 2950fps, which I'm not willing to futz with out of the AI action.