Recent content by MarkLeupold

Found this giveaway for an Impact 4000 while scrolling the social media. Seems to have very few strings attached. Thought guys might be interested in it! https://woobox.com/3d85fs

How was the match in terms of stages and movement between them? I don't recall seeing anything about movement distances, time hacks, engagement distances, round count, etc.

Got mine. Ordered 5/21 Shipped 10/26 RH SA .473

Yeah, my SA .473 order is from the end of May. I figure we've got a bit of waiting to do still

Shipments haven't stabilized out enough yet to tell. Guys are getting theirs that were ordered in February. Haven't seen anything from an order date later than that yet. It's a game of catch-up for ARC at the moment. We'll see if I get mine in November.

My current load for 25x47 is with 131gr ACEs. 39.5gr H4350. 2820 fps from a 23" barrel. GRT matches up and puts me around max pressure for the x47 case (63091 psi). As always, take it easy because the x47 case generally doesn't show typical pressure signs very readily.

16" barrel, midlength gas, gas port somewhere around .080", A5 length buffer tube, H3 buffer, full weight BCG, Springco Red or Tubb's SR-25 spring. Make sure the gas tube ends in the middle of the can pin cutout (not short) and she'll probably run. Mine does

Per our PM, I'll take it

I've been keeping an eye on a Ragnarok Sniper Challenge happening in August in Minnesota

Did anyone shoot the Ragnarok Sniper Challenge in 2022? Looks to be a "Mini-Mammoth" in Minnesota. I'm interested in doing a field match of the like with some guys of mine and wondered if someone had feedback on this event.

I've had good luck with X-Caliber barrels, though not specifically on large frame AR's. $365 is their starting price point.

Used handguard, I didn't have a typical box, lol, but I'll send them a message and see if they can do anything for me!

I've tried my BCM castle nut wrench, it's too small of a diameter. The barrel nut diameter is 1.520". Maybe one of the single tooth castle nut wrenches would work in a pinch, but I guess I was hoping for better than "in a pinch."

https://www.cmttac.com/index.php?route=product/product&path=95_98&product_id=182 Got this CMT handguard with a barrel, cannot find a barrel nut wrench for it. Does anyone have any experience or thoughts?

Very cool, thanks for the replies all!