Recent content by PBRACEGUNS

Inexpensive stock options similar to Manners T2 Boyd's Tacticool. Put pillars in and skim bed the receiver. Then inlet for the DBM if ya just gotta' have it. $105 for the stock. I'm doing one for my .223 along with doing a adjustable cheek riser like shown in a thread in the DIY section. They...

Is it necessary to quench brass after annealing? I recently built a annealing machine using 2 torches. On Hornady .308 brass 4 seconds is getting a melt on tempilac at 700 degrees. Does it need to drop into water or will air cooling accomplish the goal? Thanks in advance for any info.

I made my plate racks and full size pepper poppers out of 3/8" T1 steel plate. Thousands of pistol and shotgun blasts with no problems. I never shoot rifles at them. Sent from my iPhone using Tapatalk.

COOL GRIPS. With regards to the beavertail. You could take the stock part and add some "wings" with a TIG welder I suppose and then dress it down and blend it it. That would be a ton of work though. The sights could be done easily by a Smith with a mill and dovetail cutters. Novaks would be a...

Very slick design Gump. I have been tinkering with the idea to do a new blast cabinet Where can the pickle barrels be found?

PM inbound DocB With a question attached.

A sick day is only a phone call away Gump! " Boss I really wanted to work today but..... Enter excuse here.....!!! Sent from my iPhone using Tapatalk.

80 gr. amax shot like crap out of my .223 Berger VLD shot consistent sub 1/4moagr. 80 SMK shot really good but a full 1/4 moa worse than the vld did. Beenjammin's stick for sure shot those amax's into a very tiny group @ 600 yds.

I have been using Hornady .308 Match cases in my recently rebuild. Bought 300 from 3rd Generation, for $34 per box of 50 and a LGS has about 40 boxes at $39. It is very consistent brass as far as case weight and that's less than $1 per case. Don't know about the PRVI stuff as too it's quality...

PM inbound. Looking forward to seeing everyone again! Sent from my iPhone using Tapatalk.

1. 2000mr PP best metering and velocity+ most accurate in my .308 w/178 Amax and .223 w/ 80 gr. Berger VLD 2. IMR 4064 best in my .308 w/175 SMK 3. RL15 Haven't used it much but had shown some great potential, now if I could just find a 8 lber.

Same here. With the BTHP I ran 46gr. PowerPro 2000mr seated 2.822 coal in my Rock Creek barreled .308 @ 24-3/4" (.008" off lands) 2750fps avg. shot .3 moa. Shot well out to around 900 a little iffy @1000. 168 Amax shot .260" and held 1/2 moa too 1000. They are a really great flying bullet in...

You both did some fine shooting guys. Now if you both stay home for the next one someone else might have a chance LOL Sent from my iPhone using Tapatalk.

Send Docb a PM for rules, location and match dates. He is the coordinator for the matches.

Sounds like there are burrs on the magazine feed lips. Pull the mag and lightly sand or file then to remove the burrs. Stampings often have burred edges that don't get removed by tumbling the parts, occasionally one might miss the cleanup process. My Rem 700 .223 did the same thing. I dressed...