Recent content by targaflorio

30lbs of Varget!? Can't find any south of the border. (Are those U.S. lbs or Canadian lbs?)

I shot a bunch of Black Hills factory ammo and am using the Win brass they load. I worked up a great load with Dan Newberry's help. I also load 6.5x55 in Lapua brass. If I were starting over, I would start with Lapua.

You can outsource your brass prep to a Hide member for about ten cents a piece.

Surgikill: you are using your Dillon as a single stage? Have you tried dropping powder and seating bullets progressively on the 550 to compare results? I tried loading 308 on my 550 but couldn't get consistent headspace. Never tried it with the collet die though...

I believe the M72 used 168 gr bullets. If you are running 175s faster than the 168 factory load, that's probably your issue. I would try again at 45 or 46 grs What's your rifle and barrel length and twist?

Thanks, does it drop powder with the pull of the RL 550 handle the same way as the Dillon powder measure? No adapter hardware required?

2014 already looking to be a great year!

On a Dillon RL550, I have a toolhead set up for 45 ACP and want a second dedicated to 9mm. I was thinking about Lee Pass Through Expander die, Uniquetek Adapter and Lee Perfect Powder measure rather than buying a second Dillon Powder Measure. Anyone using that set up? Thanks and Happy New...

4064. Me too. Pretty close to varget charge weights in 308?

Good news! I just bought 1k betting on the come. But I already had good success with the 136 and 220s so not too much gamble there. Thanks for your post. Anybody loading these with 4064?

Thanks. Didn't work yesterday but worked today.

Anybody got an October code?

Yes, I send my FL dies to Forster to hone them to the same neck size as the correct bushing. Adjust headspace with a redding comp shell holder and done.

That's the lot to lot ogive variation in Sierra Matchkings? Wow, that seems like a lot. I would start seating depth like its a whole new bullet.

I started neck sizing my 300 Win. Started with a .329 bushing and switched to a .331. Now I have about 75 cases of each neck size. Is there an easy way to give them all the same bullet pull? Neck size the 331s to 329? Run them through a Sinclair expander mandrel? Carbide sizing button? Lee...