Thunderbeast RR end cap adapter group buy - 338 ultra and magnus

Mulepackhunter said:

Man is it hot here in AZ, going to have to work nights this year.
There was a question about caliber, for an FYI I have a 30 cal can and the through diameter is .450,,, I'm guessing the 338 cans are .100 plus over bullet diameter (I could use a measurement for those)
The RR brake weighs in at 3 1/8 oz (88 grams) and the prototype flat cap weighs in at 3 3/4 oz (108 grams)
Keep in mind I was unable to find a good pc of Ti without ordering so this part is all 304 stainless. The Ti version will for sure be lighter than the Brake.
View attachment 8725342View attachment 8725343

Click to expand...

Mulepackhunter said:

I sent an email out to everyone on the list Archimedes compiled. If you’re interested shoot me a message. [email protected]

Click to expand...

Mulepackhunter said:

Ran it through a stress relief heat cycle and gave its own coating which is tough to do on stainless. Ill try it on the Ti as well. The Ti will tend to go purple and black and the collar will still be stainless so it should be black like this one. Will give it some protection.
Theres enough interest now so I will order material for 10 parts this week. Also going to shoot 28 Nosler this week before shipping this out.

View attachment 8726915

Click to expand...

Mulepackhunter said:

Ran it through a stress relief heat cycle and gave its own coating which is tough to do on stainless. Ill try it on the Ti as well. The Ti will tend to go purple and black and the collar will still be stainless so it should be black like this one. Will give it some protection.
Theres enough interest now so I will order material for 10 parts this week. Also going to shoot 28 Nosler this week before shipping this out.

View attachment 8726915

Click to expand...