Search results

I am looking at possibly getting a 22wmr and found some federal game-shok 50g ammo that reviews very good. Has anyone ever used it, I have never seen anything above 40 and 45g.

I am looking at ordering these from Tacticalpants.com, has anyone ever used them? Prices seem good and have free shipping. TIA Scott

I am looking at the walther PPS in 9mm for my ccw and wanted to get your thoughts? I have also been looking at the taurus PT709 Slim any thoughts on this one would be great also. I am leaning towards the walther but have not made a decision. Looking for reliablity, function and accuracy. TIA

Are the lower parts kits for the AR15 the same for the AR10's? Is there a difference between springs due to the heavier recoil of the 308?

I was looking at the CTD catalog and noticed the 308 belted ammo with no powder or primers. It does have a bullet (fmj) but would it be possible to buy a 100 round belt for $30 pull the bullet, prime and charge brass, seat bullet and would they fire properly? If they do you could get brass and...

Well I finally got to the range this past weekend to try my hand on load work. Through help from folks here and ChadTRG42 in particular I found what I think is the "sweet spot" for my rig. My final load is Win brass, RE15 @ 44.5g, 210m primers and 168g amax (naked) set at 2.810. The rifle is...

What is the size of the allen head used to tighten the base down? Thanks

I was looking at Seekin's site and saw the DBM, has anyone used it? Also does the mag release shorten the trigger guard and possibly make it harder to get finger on trigger when wearing gloves? I could have emailed Glen on this but really want to see pics of this setup on a rifle.

I have a Falcon Menace 4-14x44 on the way and some Burris XTR rings. I have searched and found some pictures but none with this setup. From the looks of the pics I am not sure if the xtr rings will fit in the back half of the scope. Is anyone running this and can you post pics? Thanks all

Reloading for 308 in an sps-v. If the brass length is between 2.005 and 2.015 do you need to trim it to 2.005 or can you leave and just trim when over 2.015? I have been trimming to min. length every time and wondering if I could reduce my time by not trimming each time.

I am in the process of working up a load for my 308 spsv. I am using Win brass, 210m, re-15 and 168 amax. I was going to start with 42.5g,42.7g, 43.0, 43.2, 43.5 and so on to 44.7. Is this a good start or should I start a little higher with .5g increments? Also what is the norm for number of...

Can you tell me what the difference is between Nosler, Winchester, Norma, Lapua, Hornady, Federal and Remington Brass? I found lots of "this is better than that" stuff but no specifics. Which is softer, which is smaller inside kind of info. Also which ones are similar? Or if there is a link to...