Does anyone have one of those nifty illustrations of the SAAMI specs for the 6.5x47 Lapua.
I think I have a shoulder issue, I am getting a stiff bolt close, and the bolt is "pop" when I lift the bolt, just past the begining of the cam. I am using Forster Dies, and have it screwed all the way in against the shell holder, and getting this.
I screwed the die in about a 1/4 turn more, and get a slight over-cam on the handle, but I still get the same feeling in the bolt...
There is 3 firings on the Brass. OAL is 1.839 of the case. Base is .469, neck is .274.
Please Advise
I think I have a shoulder issue, I am getting a stiff bolt close, and the bolt is "pop" when I lift the bolt, just past the begining of the cam. I am using Forster Dies, and have it screwed all the way in against the shell holder, and getting this.
I screwed the die in about a 1/4 turn more, and get a slight over-cam on the handle, but I still get the same feeling in the bolt...
There is 3 firings on the Brass. OAL is 1.839 of the case. Base is .469, neck is .274.
Please Advise