Hi guys, hi the_Stewaer (I also wrote to you on YouTube that I finished making the coil)
I'm in trouble.
I just finished assembling the whole circuit.
I made a video tomorrow I'll put it down here now it won't let me put it on my phone…
Forgive my spoken English which is awful
Anyway summarizing: adjust the power supply to 42.5 v the card turns on, but as I put something inside it goes into protection. If I put it higher at 48 v it goes into protection immediately.
I followed the video for the calculations and the one for how to make the coil with 1/4 tube
This is the ZVS card (I took it on aliexpress but it is the same) 6 condensators of 0.30 uF
Measuring with the video tool 0.544 uH and following the table from a frequency that is in our working range 118.785 KHz.
The power supply acts from a minimum of 42.5v to a maximum of 53 (I stopped at 48V, as per the card indications) for 600W.
I don't understand where the problem is
Help me please