Noticed that the rear swivel in my new FN A3G is not tight.
When I tighten it, the hole thru the stub is not at a 90 degree angle to the stock.
How to you get the stub so that it's tight right at tye point that the hole thru the stud is at a 90 degree angle to the stock?
I'm thinking about just squirting some epoxy into the hole and screwing the stud in until it's at a 90 degree angle.
Update...
Nevermind. I was able to twist the swivel on around and it was very tight by the time came back around to 90 degrees. They must have just forgotten to tighten it all the way at the factory.
When I tighten it, the hole thru the stub is not at a 90 degree angle to the stock.
How to you get the stub so that it's tight right at tye point that the hole thru the stud is at a 90 degree angle to the stock?
I'm thinking about just squirting some epoxy into the hole and screwing the stud in until it's at a 90 degree angle.
Update...
Nevermind. I was able to twist the swivel on around and it was very tight by the time came back around to 90 degrees. They must have just forgotten to tighten it all the way at the factory.
