Ordered Vudoo yesterday, help on what scope rings needed!

[45srbest]

I went down to Vudoo yesterday and ordered my rifle! Meeting with Greg and Paul was a pleasure.
I will be putting a pst gen II 5x25x50 on it. 20 moa rail. Any help on rings would be appreciated. Make and height especially. Thinking .920 might be a good height.
Thank you for any insight folks!

 

[missed]

I have the 24mm tall ARC rings on mine with a Vortex AMG.

There is a decent amount of bolt clearance and plenty of scope bell clearance.

 

[Shooter_X]

Another vote for ARC. They are very nice.

 

[Phil G]

I have the same scope on my Vudoo and used EGW 30mm .990 medium rings and am very pleased. Just the right amount of bolt clearance. I believe Vudoo suggested these rings when I asked for guidance when I said I was using a Vortex PST Gen II 5-25x50.
Phil G

 

[tlsmith22]

I have the same scope as well on mine. I used a set of TPS low rings with my 30 MOA rail from Vudoo. I used those rings because I had them laying are. I love Seekins and NF rings but I have to admit, those TPS lapped in super fast. Like 2 minutes and they were done. Have plenty of room for scope caps too. If u need a pic, let me know.

 

[EchoDeltaSierra]

Nightforce SHV F1 in ARC rings here.

 

[45srbest]

Thanks for all the info folks! I still have a couple of weeks until it’s suppose to be ready. I’m thinking of the EGW or Seekins (Vortex) rings. I wasn’t aware the .990 rings would give me enough clearance. I will generally shoot 50 to 100 yards, but occasionally 25 and 200 yards. This forum is great with great people and information!