The "New" Barrett MRAD Thread!!!!!!
- Thread starter IanHusaberg
- Start date
I've tested with different bipod locations and a tripod and haven't seen a zero shift either. I still need to test with a bag on a barricade but I can't imagine that's a whole lot different than what I've already done.
I didn’t find much on vertical grips so I’ll share mine. I just swapped on the MDT Premier vertical grip. I haven’t shot with it, but it seems like it’s going to allow a more comfortable grip and better trigger control for me. I’m not crazy about the appearance of the gap it left between the grip and the receiver.
Attachments
Some MK22 hotness. The left one is a 300NM, right is the lords caliber
Can anyone tell me which pelican case model number the MRAD ships with? I just ordered a 300 prc yesterday, stoked to get it.
Last edited:
The rifle itself ships in a pelican 1750. The full deployment kit with rifle, 3 barrels, etc. ships in a pelican 1770
Greetings,
I recently purchased the .308 17” version and am looking to potentially use a Barrett suppressor. Does anyone know if the rifle came with the break for the am30 or am338 can? I ask because the am30 seems to be unavailable.
Many thanks for your input.
I recently purchased the .308 17” version and am looking to potentially use a Barrett suppressor. Does anyone know if the rifle came with the break for the am30 or am338 can? I ask because the am30 seems to be unavailable.
Many thanks for your input.
In my mind it’s to keep the number of parts to a minimum. Put the same functional break on all the versions and you’d only need to manufacture one part and that one part would work with the same suppressor for all calibers.
Where are you guys getting blanks for the barrel builders kits? Or does any mtu m24 blank work? I’m wanting to build a 7mm saw with my extra kit.
Heavy Varmint profile needed IIRC. Essentially a large shank Savage I believe I was told.
Does anyone know of an extension for MRAD mags? Id love a +5 or so, but even a +2 would make my life WAY easier.
For my fellow shortkings, the SMR baseplate for the butt pad is a direct swap with the MK22/MRAD baseplate. That cuts out about 5/8" off of the LOP. So now its perfect for me. Was about $30 from barrett ($15 part + $15 shipping). You lose the LOP adjustment, but if you needed a shorter than factory LOP, this is the way to go. Then add spacers if you want it between -5/8" and factory LOP.
Dissasembly was pretty easy, just need to remove a C-clip, rest can be done by hand.
Dissasembly was pretty easy, just need to remove a C-clip, rest can be done by hand.
Last edited:
Can you please tell me what pill you are using and what type of velocity you're getting?
Makers kit needs 1.25" and will be milled down to 1.247. OD of threads will be 1.188".
Similar threads
