Re: What triggers will fit in an AICS stock
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: radmcg</div><div class="ubbcode-body">How did you trim them with a file? just doesnt seem to be that much extra but i had rather file a 200$ trigger than a 800 stock. </div></div>
yes, i filed them. there is one pin that goes completely through the trigger assy that needs the head thinned and the other end shortned-just leave what you think needs to be there to hold the the "C" clip.
then there are two rivet heads on the safety gizmo that needs thinned. again, leave enough to hold stuff together. if you pull the skins, put the barreled action into the chassis and look from the bottom, you can see the pin/rivets that cause the grief.
then clean the trigger out completely (i used brake cleaner/compressed air, most people reccomend lighter fluid/canned air)
this worked for both of my AICSs, a long action and a short action.
if you need, i can post a pic, but i'm going to Moab shortly and won't be back till next Tues, if you can wait till then.