Hi there, I got a Zeiss discount cert and is debating between S3 6-36 and S5 5-25 for prs centerfire rifle. Does anyone have experience with both of them?

Simple question would be: is S5 $700 better than the S3? I have tried my friend's S3 at the range and find the eyebox bit tight comparing to razor gen3 and leupold Mk5, while the clarity is decent.

If the S5 got better eyebox and better glass quality, I personally would think probably it worth the extra cost.

Brand new. Wouldn’t work with my trigger hanger so selling it.

$200 shipped SOLD

-Shaw 18” 450 bushmaster 416r stainless HBAR 1-24 twist 11/16-24 thread with Faxon low profile gas block and gas tube. Barrel is unfired but does have scratches on it from sliding on gas block and hand guard.

-Wilson combat forged 458/450 upper receiver with forward assist, Magpul dust cover and Wilson combat large lever charging handle.

These parts were installed on a build that was never fired.

$325 shipped to lower 48 UPS ground.

Selling a few items I have lying around. I do not have the original packaging for any of them.

SB Tactical FS1913 = $125 shipped SOLD
SIG minimalist plus = $175 O.B.O shipped
SIG minimalist = $175 O.B.O shipped

CHASSIS SOLD TO LuvDog......

Muzzle Brakes $130 each shipped...all 6.5 and threaded 3/4-24....3 ATS Brakes 1 ACE Brake.
1 ATS BRAKE SOLD TO 406Shootist

Mounts are all sold!

Added….
2 AICS mags with Area419 +4 adapters and factory floor plates $100 each shipped

BOTH GRAY OPS BAG STOPS SOLD

Figured I would start a thread so people can talk about Bags and Fill options. I got to play with some spexlite at a match recently and am thinking about ordering some of this stuff. I have 25lbs of bags in my kit, and would like to take some of the weight out of my pack. All the bags have had some fill removed so they are more shootable. I used to run glass bags but they have gotten so heavy and end up tearing up the bags. I usualy only get about a year out of a gamechanger before the seams blow out and I just replace them. I am thinking a lighter fill will be less wear and tear on the bags and as long as its still shootable, could be a move in the right direction.

AG Plus one with Sand - 13lbs
AG Smediums with Sand - 8.5lbs
AG Smedium with Poly Beads - 4.5lbs
AG Pint sized with Sand - 7.3 lbs
MDT Peanut with Sand/Glass - 8.3lbs
Cole Tac Plate Bag with Grey Ops Pro Plate Filled with Glass Beads - 4.7LBS

The heaviest spexlite beads 5235 would be about 5.5-6Lbs in a Plus one, so about half what the heavy sand is. https://www.boxtobenchprecision.com/store/spex-lite-5235

There is also the Olympic mix which is 5325 and 5125. https://www.boxtobenchprecision.com/store/spexlite-x-ginny-thrasher-olympian-shooting-bag-fill

What do you guys who shoot PRS run? I know its tough to beat heavy sand but there may be some new options that get some of the unnecessary weight out of our kits. It would also make flying with them much easier.

Looking for some feedback on the Pure Precision SKLTN action.

I would like to buy a bigger shooting bag. Let me know what you got.
Thanks

MPA BA Bolt Action one piece mount. 34mm - 1.125 - 0 MOA
Great condition, no dings, dents or scratches

$120 shipped USPS Priority / PayPal FF or plus fee

In on trade Trijicon 1.5x16 compact ACOG 2moa center dot with mount. $SOLD shipped.

New only mocked up for a build

260 shipped

New in box (SKU100042) 6.5CM AR10 Carbon Fiber Proof Research Barrel $750 shipped. Venmo/PP F&F

Unfired barrel

Geissele gas block and tube

265 shipped

Zelle

Excellent condition. Glass is pristine. Comes with everything as when purchased new plus caps for both ocular and objective lenses. $SOLD shipped conus. Not looking for any trades at this time. Thanks.

I have a Leupold VX3i-LRP FFP MOA scope for sale. $600 with the rings and bubble level. It has been a great scope, I just switched everything over to MILS finally. I’ve used this in PRS matches as well as hunting and it never let me down. Open to trades if you have something interesting

Selling a used Burris XTR 2 5-25x50 scope in FDE with the SCR MIL reticle and MIL turrets. Bought it used but decided it was too much magnification for my application.

$500 shipped.

Recently at ALTUS I was connecting with a silhouette at 1039 yards. (According to my range finder). Tricking a ballistic calculator to give me midrange trajectories, I noted that the bullet traveled 70 yards between 112.22 and 112.25 inches above line of sight with a maximum height of 112.59 inches. (Between 540 and 610 yards)

Knowing the effects of negative G’s (having done so while piloting to watch my pencil float) I am wondering if the time when the bullet sets at the top of its trajectory and starts downward towards the flight if it experienced loss of weight, (weightlessness) without obviously loss of mass.

Maybe not a comparison, but felines finish their jump just past the top of the apogee to have a negative weight and thus silent landing.

Note to trick a ballistic calculator to give midrange trajectories, set the range you are shooting to the “zero range”.

Original owner with under 100 rounds down the barrel.
Shoots factory 140 match very well and my Berger 140 loads are under .5”

I bedded the action with acraglass as it wasn’t shooting like I wanted out of the box and that instantly made a difference in this rifle.
Some of the factory paint chipped off in the process and I just went over it with some dark gray paint. You can see it in the pictures.

I added the following:
MDT 20 moa rail ($70)
Trigger tech special 2 stage flat trigger ($250)
Sawtooth rifles arca rail made for the ridgeback. ($109)

Bipod not included. Pricing well below what I paid for just the rifle new. Great rig but I hardly use it and not worth it to just sit in the safe.

$1550 shipped to your ffl.

No trades.

Used but good shape. Comes with the exomtngear pouch.

$190tyd

Looking to see what transferable machine guns are out there for sale

browning m2 is at the top of the list

But let me know what you have

size small yoke. some minor piling on the back. otherwise no signs of use

310 shipped

2500

everything is new. all parts are lmt
trigger is lmt 2 stage axle-euro. saftey works with hammer fired.
barrel is not torqued.

atlas bipod

Mike got back to me and is unfortunately no longer making bore guides at this point in time. What else is out there I should grab? I've got an Impact Precision 737r on order and a barrel chambered in 6.5mm CM, and a Pro-Shot cleaning rod. (22-26/42").

I've seen the 21st Century: http://www.xxicsi.com/bore-guide.html
Sinclair models: https://www.sinclairintl.com/gun-cleaning/rod-guides-bore-guides/index.htm
I've had a Possum Hollow but he no longer responds email or answers the phone and his VM is full (I'm over it, no thanks on these)
Bruno: https://www.brunoshooters.com/product/81006.html

Not sure what to go with for my setup, so any suggestions would be welcome.

Looking for a right hand, SA AXSR Chassis. FDE or Black is fine.
Let me know!

6mm creedmoor barrel 600 rounds throw it 26” for Mac bros evo 2
325 shipped
No action already sold it
Also have some Lapua 1’s fired brass (dirty) if interested as well