Recent content by pdice

I think I'd like to get a second 308 barrel for my rifle. It's currently a tooley remington pattern action with a 260 rem barrel on it. What should I expect for POI shift when re-torquing the 260 barrel back on?

SPF

I'd like to sell my lightly used annealeez for $250 shipped. I used it approx 3 times.

Has anyone tried ez-anneal yet? I like that they already have a case feeder for it, and I haven't read about a cool down cycle yet like with the AMP. http://www.ez-anneal.com

I'm going to use this for a partner DMR match, so one of us will be on the spotting scope. If the card is mounted to the scope, having it as close to the scope as possible I think would be best.

That's definitely what I'm looking for, but $175 is crazy.

Has anyone see a mount, preferably metal, that I could put a dope card on that would have a pica tinny clamp that I could clamp to the rail on my spotting scope?

Thanks, exactly what I was looking for.

It's new brass

Does anyone know if southwest ammo has sold 260 brass on its own before? I'm trying to figure out the sell or trade value of it. I think I want to stick to only one brass type for my reloads, and I have more of another brand.

Does anyone have experience with a setup like this? I'm not sure the HDMR is even going to cleanly fit in the mount.

I'm thinking of getting a manfrotto 190 CX3 to replace my older aluminum manfrotto for my spotting scope. The things I like about it are that it is lighter than my old trip, and with the head I have a lot of ways to set it up, including next to me when prone. Are there any other tripods I...

Does anyone have a good reloading sheet to fill in for each of my loads? I've been searching for a while, but I haven't found one I quite like yet. I'd really like to put on there a diagram for the bullet and its attributes including neck sizing info, OAL, and then a fps with zero conditions.

Re: Will SWFA ever put out a spotting scope? SWFA, has there been any movement lately on this?

Re: Competition seating die worth it? How do these dies compare, in terms of runout, to the wilson hand dies that are used with an arbor press for seating?