Ok the machine is an autodrive super 1050 by ponsnesss/warren.
Anybody have any experience with these? I'm having trouble with the resizer/decapper die hanging on brass, especially in automatic mode. The problem seems to be that I can't get the decapping pin to set out far enough to decap the round before the neck hangs up and jams the machine up! I've extended the decapping pin out, to far apparently, because it resulted in the pin bending!
However, If I run the machine manually, I can get this done and it still hangs just slightly, but does not jam the machine!
I'm thinking it's a length of stroke issue, because in the automatic mode, it also does not seat the primer in the pocket as far as it needs to be. Other then that it works fine. I really think I just need to replace the sizing/decapping die and run it manually as you can run it faster that way then you can automatically.
I'll try to get machine info posted. I was just wondering if anybody else had any experience with these and could give me any helpful info. Thanks Jason
Anybody have any experience with these? I'm having trouble with the resizer/decapper die hanging on brass, especially in automatic mode. The problem seems to be that I can't get the decapping pin to set out far enough to decap the round before the neck hangs up and jams the machine up! I've extended the decapping pin out, to far apparently, because it resulted in the pin bending!
However, If I run the machine manually, I can get this done and it still hangs just slightly, but does not jam the machine!
I'm thinking it's a length of stroke issue, because in the automatic mode, it also does not seat the primer in the pocket as far as it needs to be. Other then that it works fine. I really think I just need to replace the sizing/decapping die and run it manually as you can run it faster that way then you can automatically.
I'll try to get machine info posted. I was just wondering if anybody else had any experience with these and could give me any helpful info. Thanks Jason
