I was just trying to pull some of those little junk screws remington blocks off the scope mounting screws with. The little bugger just spins and spins and did I mention spins without coming up enough for me to grab it at all.
I have had several of those little screws do this in the past but always was able to get them up enough to extract them with neddle nose pliers. I do not see any hope of that with this one.
I decided I would drill a little hole in it and then be able to pull up on it with a little tap threaded in the hole. No dice the drill just spins the whole screw.
If it were the hole over the front action screw I could get it out, but of course this is the blind hole over the barrel shank. I hate to pull a barrel just to get the damn thing out, any suggestions advice for geting it out?
I have had several of those little screws do this in the past but always was able to get them up enough to extract them with neddle nose pliers. I do not see any hope of that with this one.
I decided I would drill a little hole in it and then be able to pull up on it with a little tap threaded in the hole. No dice the drill just spins the whole screw.
If it were the hole over the front action screw I could get it out, but of course this is the blind hole over the barrel shank. I hate to pull a barrel just to get the damn thing out, any suggestions advice for geting it out?