I am selling my Giraud power case trimmer. It is currently set up for 308. Comes with everything that is original. I am selling it for $450.

Imagine was to large so here is a link.
https://ibb.co/HnqC9Hm

Not sure if this is the right spot for this, feel free to move if needed.

I have seen a serious drop in the consistency of some factory “match “ ammo the last few years.
Wondering if there is any ammo manufacturers that have maintained pre C19 quality.

My own use is 308, 6.5 and 6cm but have seen the same in other calibers as well.

.

I am selling my Fn SPR a1 rifle. It has seen very little use, round count is around 400. The barrel has been threaded 5/8-24 and has a 2 port muzzle brake on it. It has the Fn tbm bottom metal which I have 4 mags for. 1-10 round and 3-5 round. Also have the factory bottom metal and mag. I painted the stock.
Rifle is very accurate with the reloads I have and also with fgmm 175 ammo.
I have 121 reloads for it and 159 pieces of 2x Peterson brass.
I would like to sell everything together as I am getting out of shooting 308.
For rifle, mags, bottom metal, reloads and brass I’m am looking to get $1700
Message for any other questions.

Beautiful scope just looking for more magnification. DLR / CCW / SKMR4
$2700 shipped OBO

He is looking pretty rough. F!@$ cancer

Login to view embedded media

Barreled action by RWS
Defiance tenacity
Proof stainless
Threaded and blended cap
New never fired
$1800 shipped

So after searching this forum and elsewhere online, and basically finding no source of information on this, I figure let’s start a thread on the apparently VERY little known M83 sniper rifle, built by NSWC Crane for the Navy SEALs sometime in the 1980s, before the M86.

I will share the little information I have been informed about, and let others with actual direct or otherwise knowledge share what they wish, including any photos of either actual or clone M83s.

From what I have gathered, the M83 was built in-house at Crane and consisted of the following specs:
- Remington 700 short action chambered in 7.62 NATO, mostly with the ADL blind magazine box
- McMillan silhouette stock in early desert smear camo (with the green)
- Custom made scope base with 30mm Leupold & Stevens Ultra rings
- Either an L&S Ultra 10X with M1 turrets, or a Bausch and Lomb 10X Tactical scope

And of course this all centers around what is usually my favorite part of a build, the McMillan stock. Below is a mostly exact same stock as used on the M83, with the exception of a different butt pad (but that can be easily fixed).

Ive got:
Atacr 7-35 F1 mil-r $2500
(2) 5-25x56 F1 mil-R $2400 each
4-16x42 F1 mil-R $2000

Tyd. All in great shape. Will get pictures. Have boxes and paperwork for all

Im looking for:

2x 4-16x50 F1 mil-c
2x 5-25x56 F1 mil-xt
5-25x56 F1 mil-c

Would be willing to do some trading or buy outright.

PayPal, venmo, face to face, etc. Located in southern IL

Had a full case, sold 2, so 8 boxes left. 125$ ea PLUS SHIPPING. PP F&F or check by mail. Would prefer to sell in large lots if possible. 2 boxes per order minimum.

Send a pm, posting "I'll take it" is your own risk for a scam. The O in my user name is an OH not a ZERO. Different guy was scammed using that tactic a while back. Be smart, don't be a tard......

Looking to sell my NHC collection:

The only Nighthawk I have ever fired was 10 rounds through the Bob Marvel. All others were factory sighted in and I have all the cases and factory targets.

Nighthawk Bob Marvel 10MM. I had this custom made from Nighthawk in 10MM. Not sure if there is another in the country. IOS upgrade. Trijicon RMR2 3.5 MOA $8000.

Nighthawk Firehawk .45acp IOS upgrade, Mammoth Grips, Trijicon RMR2 3.5 MOA $6500

Nighthawk President 9mm IOS upgrade, Mammoth Grips $6500

Nighthawk Colt series 70 .45acp $3500

Nighthawk Agent 2 .45ACP with IOS upgrade, Trijicon RMR2 3.5 MOA $6000

Nighthawk Warhawk 9mm IOS upgrade, sent to factory, Not sure there is another in the US. Trijicon RMR2 3.5MOA $6200

Most of these guns, if ordered from nighthawk today, would take 2-3 years to deliver. These are available immediately and I am willing to ship to your FFL.

If you want to buy the entire package, we can negotiate on price. Serious Enquiries only please.
NO TRADES.

Located in parker Colorado. Viewings can be arranged upon request.

Lower right quarter, just right of the vertical stadia below the reticle tree. Looks like bubbles in the glass. I've had this scope for almost three years now and just now noticed this because I rarely shoot below 12X, power setting in the pic is 5X, scope pointed at an off-white door so the glass bubbles hopefully show up better. Now I've looked through this scope below 12X at least a couple times in the past and never noticed them. Leaves me wondering if this is something that can develop over time or something that was always present and I just wasn't paying attention. Anyways, what are your thoughts, advise, opinions, jokes etc..... Send it in and have the manufacturer look at it (Tangent Theta btw) or just live with it like I have been? This isn't a complaint thread, just a mild concern, this scope has served me well.

Auto-Trickler V4 w/all original accessories for sale.

Only used this unit for a couple of weeks, then changed solutions. It's in like new condition with manual and all original accessories.

$380 - Shipped to CONUS.

Payment: PayPal FF

Note: Area 419 Loading Block is not included

This is a barreled action, and the barrel work was done by LRI, please see the specs below:
No Trades

• American Rifle Company Coup De Grace Action
  • Short Action
  • Pivoting bolt handle
  • Spiral fluted bolt
  • 30 moa top rail
  • Hour glass & ball bolt knob included
  • 0.473 bolt face
• K&P barrel
  • 1:7 twist
  • 1.20" straight
  • 25" finish length
  • Black cerakote with stainless engraved LRI logo
  • Chambered in 6.5 CM to shoot heavier 6.5 cm projectiles
• Area 419 Hellfire match 6.5 brake

I set up this rifle to shoot 144 bergers, and it shoots them EXTREMELY well. The action is crazy smooth (I prefer it over my impact). I am only selling because I lost access, I had to a 1600-yard range. The rifle has about 60 rounds through it and easily shoots .1-.3".

The build as it sits ran a little over $2300, I am asking $2100 $1990, $1890. It is in perfect condition and ready to ship, I will cover the load data with the buyer if desired.

Testing this new US primer on .260Rem.
Login to view embedded media Login to view embedded media

MDT HNT26 folder for Rem short action/clones with 1 short action mag magazine (6.5 PRC, 300WSM, etc)

Excellent condition. Black carbon.

1250 (net), shipped

Hello,
I think to buy a Rotary tumbler for wet cleaning of my brass.
I look at Frankford Arsenal tumbler, Lite or Platinum.

About the Platinum on the net are good comment buy on the Lite someone claim some problem like the brass don't rotate on the tumbler.

Can you tell me some impression about this two tumbler?

I know also some chinese rotary tumbler, 3 or 5kg, someone on this forum use this version?

Thanks in advance!

Looking for advice for a 22 build and what barrel to use on the rimx action

Duck

Login to view embedded media

I am selling my Autotrickler and scale. It is the V4 with everything in picture. It has the area419 and powder catch for the bottom. I have used it to load about 700 rounds so not much use to it and works great. I am selling it for $950 shipped.

Need this gone as I no longer have a 6.5. $350 shipped. Thanks for looking..Paypal or venmo preferred.

Comes with original box and sunshade. $3200 Shipped.

Pics below. Paypal F&F or Zelle accepted.

2 AW mags.
One is new, never used. Inserted in my gun a few times. SOLD
One used with original spring and follower as well as a HRD br kit. SOLD
Take em both for $225 shipped.

New in box, Leupold Mark 5HD 5-25 PR2-mil. Model # 180222.

Pm with any questions.

$SOLD shipped!

If you get a chance, step outside tonight you might see something like this.