I am relatively well versed with firearms but was recently wondering, what is a defining parameter for a rifle being "high power"? A quick internet search said "anything with a muzzle velocity over 2000 fps". I found this to be unsatisfactory as I had some factory 50g 9mm pistol ammo with greater than 2000 fps. and velocity doesn't sound like power as much as muzzle energy would. I would definitely not consider 22lr as high power, and would definitely consider 300 win mag or 7 rem mag to be high power. But what about cartridges such as 223/556, 308, the creedmoors or even 30-30?

I was just curious.
Thanks all

Hornady 300prc brass. 26pcs once fired. cleaned and tumbled. $30 shipped.

In Perfect condition,
$300 Shipped
PPFF or Zelle

Title basically says it. I'd like to find some private land to hunt any or all of:

squirrel
rabbit
chucks
(maybe) 'coons
coyote
fox
(maybe) upland birds
(maybe) waterfowl
(maybe) deer

In about that order of interest. I've also got a couple flyers up at the clubs I shoot at but figured to throw a feeler out here as well.

I currently hunt public lands for mainly squirrels and rabbits but majority of them have the season significantly reduced from the state-wide season. Some are as short as two or three days out of 6 or 7 months.

Ideally like to find someplace within 0 to 4 hours any direction of NW (Lake/McHenry Co). I'd be hunting mostly with 20ga shotgun, .22lr, .17hmr.

If anyone has a spot or could link me up with one, I'm sure we could work something out.

Used gray MPA Matrix Pro, Rem 700 SA inlet in great condition but with some nicks and wear as pictured. Catch and release decided to stick with my other chassis. Asking $860 shipped CONUS

Expected a little better velocities, groups, and deviations than this… Really don’t know where to go with powder, I do have Ramshot Grand that I might try despite having zero load data to go on…

ADG Brass, new, neck sized, mic’d for neck wall thickness, length checked, etc.

Tikka built as a long action, 22” 1-7.5tw barrel, 180gr ELD-M, H1000 powder, CCI LMR, 3.117” OAL, 0.050” jump.

I saw no pressure signs on any of these loads despite loading 0.6gr over the max Sierra recommends. None were even close to a compression load, I may try a few loads with more powder.

I bought this rifle for a hunt that never materialized. The rifle has around 150 rounds on it. It was thorated for the 156gr Berber EOL. It is an absolute tact drive and shot factory Berger 156gr ammo under 1/2 MOA. No scope or rings included, rifle only.

This rifle was a complete build by Ryan Pierce of Piercision Rifles.

Defiance ANTI X XM Action
Bedded Manner LRH
Hawkins XM M5 Hunter BM
2x 10 rd mags
22" Benchmark Caron barrel 7.5tw
TBAC 30CB Brake
Triggertech Diamond
Ryan timed the ignition

$5,000 shipped
$4,500 shipped
$4,000 shipped
$3,750 shipped

And the media IS THE PI**a G@te!!!

(I redact because someday they will bot search key words for (((redactions)))




Gee, why does he not appear on Wiki?



GO LOOK FOR YOURSELF.

The lack of locking turrets on the Cronus has always bothered me, so I made this little cap that solved the problem. It is possible to squeeze it hard and rotate the turret, or really beat the hell out of your scope and it might move; maybe

Made 2 styles, one with a magnet, for frequent dialing, and one without, for a set it and forget it type setup.

I made some of each for myself and friends, have a few left if anyone is interested?

The only thing not Made in the USA is the magnet. Comes with zip ties and 80lb braided line for mounting options.

$15 non-magnetic shipped. EDIT: Now $10 each shipped, $6 each additional.
$18 magnetic shipped. EDIT: Now $13 each shipped, $9 each additional.

100% money back guaranteed if you’re not satisfied.

FYI: I work road construction full time, getting to the post office may take a couple days due to my ever-changing schedule. Thanks for your understanding.

Brand new vortex in reptilia mount , have box for razor as well want to sell for $1900 with the mount ,

scope and mount are brand new i put it on rifle and zerod and never shot again
have box for scope will ship in box , optic is MILs

Tikka T3x Roughtech in 7 REM Mag. 30mm medium Talley rings. Less than 100 rounds fired. I bought it for an elk hunt last year that never happened. $650 shipped. If your local in TX I’ve got a bunch of factory ammo I’ll cut you a deal on.

In Lafayette, the city where I live. I know there are a lot of Muslims living here, which makes me wonder if there might be a cell active here. With this no kings bullshit set to happen this weekend my head will be on a swing so even more than normal, I promise you that.

LOWLIGHT APPROVED POST !


I am taking pre-orders for the new release Vector X binoculars. I am a Vectronix listed dealer.

PM for pricing. I will answer PM's as quickly as I can.

These will be coming in very soon. Limited amounts of them at first and more in the coming weeks and steady flow by the end of year.


- Equipped with a 905 nm laser engine that measures up to 6500 m/ 7000 yd
- Has a sensor suite that measures azimuth, inclination, temperature, barometric pressure, and humidity
- With its bright, color-neutral image, high contrast, and wide field of view the VECTOR X is your go-to in situations where every detail counts
- Comes standard with an integrated tripod adaptor
- Offers three models to cater to different preferences: 8x42, 10x42, and 12x42
- Comes standard with Applied Ballistics Elite inside and displays complete firing solutions (two windage values/one elevation value) on a single HUD screen







Login to view embedded media

Wyoming residents will be charged sales tax and All others are responsible to pay their own state taxes if applicable.

Does anyone have any load data for 6mmBR and LT-32 powder with 80 grain Berger? Thank you.

Selling used True Bore Alignment System w/ D1-4 adapter. TBAS works perfectly and is in very good condition.

$800 shipped.

Aero Solus 15” Grey chassis. Few nicks but over all in good condition. I used it on my Vudoo for a couple months. $475 shipped.

This is an aggravating one for me. Just didn’t pay attention to the ad while looking at a price that was too good to be true. Accidentally grabbed a second focal plane ATACR. Noticed when I went to sight it in.

This thing is like new! Been out of the house for ten minutes and had 7 rounds through it before I caught I ordered second focal plane

ATACR 7-35 Mil C reticle
34mm tube
Comes with alll accessories from NF
Has turret tape to mark turrets with dry erase marker as well

Pictures speak for themselves and looking to get 2000 shipped and insured

Would entertain trades for high end watch
Swaro binos
Impact 223 bolt and 223 barrel
Impact 25x47 barrel
Impact 22gt barrel
Impact 6x47 barrel
Bushnell LMSS spotter with reticle

Selling a like-new RH50R purchased October 2024, still under full factory warranty. Comes with original box, hard carrying case, battery and Bobro mount.

Key Specs:

• Thermal Sensor: 12 µm Micro II core, <20 mK sensitivity, 60 Hz refresh rate, detection out to 1,750 yd
• Optics: 3× optical magnification + 4× digital zoom, 50 mm F/1.0 objective, 8.8°×6.6° field of view, 60 mm eye relief
• Display & Imaging: 2,560×2,560 AMOLED HD display on MATRIX III processor, picture-in-picture mode
• Power & Storage: Removable IBP-5 Li-ion battery (5+ hr runtime), USB-C external power, 32 GB onboard video/image record
• Durability & Extras: Magnesium housing, IP67 waterproof, 1,000 G/s² shock resistance, recoil-activated video, eight reticles, one-shot zero, WiFi/app connectivity, firmware updates

NOTE: Eyecup is missing, I never used it anyway.

$4000 OBO takes it.

Open to local trades in the Sioux Falls area, willing to sell to USA 48 otherwise. Payment via PayPal or Venmo F&F. Timestamped photos available on request to prove legitimacy. PM me for details.

I have 185 Barnes 7mm 171 grain Match Burners for sale. $55.00 shipped and insured for them all. Methods of payment are Gun Tab (you pay the fees), check or money order. These are also for sale on the Long Range Hunting Forum.

I'll trade these for 140 Sierra 7mm 175 grain GameKings.

All,

Love this system but just too much gun for what I can do. Have to fly to Texas to even test it.

MRAD with 300 PRC Proof barrel and 6.5 Creedmoor heavy barrel. less than 80 rounds through the Proof and less than 300 through the 6.5.

2 6.5 CM magazines and 1 300 PRC magazine.

$5600 for the package with hard case and monopod included. Optics and bipod NOT included. Original MRAD handguard included.

Only trades would be 16"-20" Geissele, JP Enterprises, GA Precision, or LMT Mars in 6.5 Creed plus cash or optics.
Attach files
https://www.snipershide.com/shootin..._id]=36&hash=cab3c8734496e06bc2ac7bcdcbabf8e1

Have a buddy looking for a 7 saum carbon barrel for an Impact. Let me know what you have

Get this off my bench before I start building again!

OG LMT Defender AR lower (minus trigger group). All original LMT save for the Magpul trigger guard and buffer components
Colt H2 and Springco Blue spring.
Milspec upper (Cardinal Forge mark)
Magpul PRS gen 3 gray.

Asking $425 shipped as shown
Must ship to FFL
Zelle or discreet payapl gift. NO TRADES

Good condition.. does have some handling marks from being used ( but not abused) and in and out from the safe. .

For Rem 700 S/A and clones .. awesome chassis for the money

$575 shipped CONUS
PAYPAL F&F PREFERRED

I have tons of NF optics in stock, Ready to ship. PM the NF CXXX model you are looking for.
Below Map pricing. ​

​

Here are just a few:​

I have NIB C571 Ready to Ship MAP $3850. Message for Hide member Pricing.​

​

Specifications​

• Scope Weight:39.3oz
• Scope Length:16.0"
• Magnification Range:7-35x
• Scope Objective Diameter:56mm
• Scope Tube Size / Mount:34mm
• Turret Adjustment (Click Value):.1 mrad [adjustment]
  27 mrad [elevation]
  16 mrad [windage]
  12 mrad [per revolution]
• Elevation Turret Details:Exposed
  ZeroStop
  100 MOA/29 MRAD
• Windage Turret Details:60 MOA/17 MRAD
• Parallax Adjustment:Side Focus 10m-∞
• Reticle Position:First Focal Plane
• Reticle Details:Illuminated Horus TReMoR3 Reticle
• Field of View:7x: 15ft; 35x 3.4ft (@ 100yds)
• Exit Pupil:6 -1.6 mm
• Eye Relief:83-91mm/3.3-3.6"
• Illuminated Reticle:Yes - DigIllum
• Scope Finish:Matte Black
• Scope Turret Rotation:Counter Clockwise (CCW)
• Product TypeRiflescopes
• UPC847362014524
• MPNC571

​

Nightforce ATACR P-VPS 7-35x56mm MILSPEC Full Kit.​

​

I have NXS, NX8, and ATACR optics, and Accessories.​

PM the CXXX model you are looking for.​

Attachments​

• 
  IMG_6067.jpeg
  482.6 KB · Views: 65
• 
  IMG_6651.jpeg
  161.4 KB · Views: 68
• 
  FeatureImage-1.jpeg
  706.5 KB · Views: 75
• 
  IMG_1284.jpeg
  379.5 KB · Views: 73
• 

KAC QDC/CRS suppressors $1730​

I have Black and FDE 762 KAC QDC/CRS-PRG, Knight’s Armament QDC CRS PRG 7.62 Rifle Suppressor KAC’s newest answer for a superior rifle suppressor — 3D printed and incorporating their Pressure Reduction Technology KAC PN 121568-BLK & 121568-FDE Connects to all 7.62 QDC Muzzle Devices. Available in Black and Flat Dark Earth (-BLK) (-FDE). Specifications Addition to Bare Muzzle: 6.3” (16cm) Addition to QDC 3-prong FH: 5.65” (14.35cm) Overall Length: 7.9” (20.06cm) Weight: 23.2oz (658g) Sound Reduction: 26dB


Also

Knight’s Armament QDC MCQ PRT 5.56 Rifle Suppressor FDE and Black $1730​

KAC’s newest answer for a superior rifle suppressor — 3D printed and incorporating their Pressure Reduction Technology (PRT)​

KAC PN 121567-BLK & 121567-FDE

Connects to all 5.56 QDC Muzzle Devices. Available in Black and Flat Dark Earth (-BLK) (-FDE).

Specifications
Addition to Bare Muzzle: 5.67″ (14.41cm)
Addition to QDC 3-prong FH: 4.15″ (10.55cm)
Overall Length: 6.25″ (15.88cm)
Weight: 19.2oz (545g)
Sound Reduction: 24dB

Attachments​

• 
  IMG_3183.png
  34.2 KB · Views: 69
• 
  IMG_3184.png
  20.7 KB · Views: 71
• 
  IMG_3185.png
  36.1 KB · Views: 62
• 
  IMG_3186.png
  21.9 KB · Views: 68

Purchase now, I will hold then at no fee until you are ready to take advantage of the 1 JAN 2026 new Suppressor Law. Get them while stock is up.

PM any Questions.